Knife edge loads – representation of wheel axles, Civil Engineering

Assignment Help:

Q. Knife edge loads – representation of wheel axles?

In BS5400 traffic loads for HA loading are given by uniformly distributed loads along loaded length and a knife edge load. In the code it's not intended that knife edge loads simulate a wheel axle of vehicles. In its place it is just a tool to provide same uniformly distributed loading to imitate bending and shearing effects of actual traffic loads.


Related Discussions:- Knife edge loads – representation of wheel axles

Resting on several raking piles, Question Should dolphins be designed i...

Question Should dolphins be designed in a rigid manner such as resting on several raking piles? Answer While designing dolphins, they are normally supported on a syste

Define hardness - chemical characteristics of water, Define Hardness - Chem...

Define Hardness - Chemical Characteristics of Water Caused by any polyvalent cations (mainly Calcium and Magnesium). Expressed as mg/l as CaCO 3 . Causes precipitates with soap

Explain some important points for hazardous waste, Explain some Important P...

Explain some Important Points for Hazardous Waste The mixture rule prevents dilution of waste for the purposes of escaping RCRA regulation. Mixtures of a listed hazardous w

Determine the load which a square footing, Two load tests were performed at...

Two load tests were performed at a site-one with a 50 cm square plate and the other with a 75 cm square plate. For a settlement of 15 mm, the loads were recorded as 50 kN and 90 kN

What is froude number - hydrolic system, What is Froude Number? Used to...

What is Froude Number? Used to determine if the flow is rapid, critical or tranquil.  Fr = 1 critical flow; Fr 1 supercritical flow In rectangular open channels:  Fr =

Define storms - underwater inspection of bridge, Define Storms - underwater...

Define Storms - underwater inspection of bridge? Storms can have a detrimental effect on bridge substructure. The velocity and depth of water and debris carried increase in rel

State the term directly below the edge of the footing, The load from a cont...

The load from a continuous footing of 1.8 metres width, which may be considered to be a strip load of considerable length, is 180 kN/m 2 . Verify the maximum principal stress at 1.

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd