Improvements to public bus transport, Civil Engineering

Improvements to Public Bus Transport:

Since buses carry a large number of passengers, improvements in bus transport is a cheap solution. Some of the possible improvements are:

(a)        Exclusive Bus Lanes, where only buses can run. The High Capacity Bus System (HCBS) being planned in Delhi is one such.

(b)       Introduction of buses with low floors, so that passengers can get in and get out easily.

(c)        Introduction of vestibule buses, doubling the seating capacity.

Posted Date: 1/23/2013 2:16:00 AM | Location : United States







Related Discussions:- Improvements to public bus transport, Assignment Help, Ask Question on Improvements to public bus transport, Get Answer, Expert's Help, Improvements to public bus transport Discussions

Write discussion on Improvements to public bus transport
Your posts are moderated
Related Questions
CEMENT Cement is a normally used binding material in the construction. By burning a mixture of argillaceous (clay) and calcarious (calcium)  material at a very high temperature

Q. Good surface regularity for sub-base in concrete pavement? Surfaces of sub-base material for concrete carriageway must be built in a regular manner due to the following reas

Relation of the angle of contact between pipe invert and bedding material to the load resisting capacity of pipe Minimum crushing strength is a generally adopted parameter for

Q. Protection of line in case of ‘STOP DEAD RESTRICTION' for carrying out a work of short duration on a single line section on a B.G. route  Ans. Protection in block sectio

Ground settlement occurs when pipe-jacking machine enters mixed ground with soils and boulders? The rate of cutting through soils is faster than cutting through boulders for pi

Explain the Selected Bridges - Underwater Inspection? Those bridges, which require underwater inspection must be noted for individual inspection and inventory records as well b

Define Types of Seismic Isolation Bearing - Rubber Bearings? Seismic isolation is obtained by two types of isolation bearings. a) Rubber bearings b) Friction pendulum bea


Obtain the values and direction of the supporting reactions of the truss given below. Use the method of section to determine the forces in each member.

Discuss about the post-tensioning systems In most of post-tensioning systems, when the cable is tensioned and the jack is released to transfer prestress to concrete, the fricti