Immediate addressing , Electrical Engineering

Immediate  Addressing

In this  addressing mode that 8/16  bit data  is specified  in the  instruction itself  as its  one of the  operands. Normally the instructions  using  addressing  mode have I in their  mnemonics.

MVI A 33H

ADI  05H

SUI 20H

ANI 02H

LXI H 2050H etc.

Posted Date: 4/5/2013 3:06:58 AM | Location : United States







Related Discussions:- Immediate addressing , Assignment Help, Ask Question on Immediate addressing , Get Answer, Expert's Help, Immediate addressing Discussions

Write discussion on Immediate addressing
Your posts are moderated
Related Questions
The operating frequency range of a superheterodyne FMreceiver is 88-108MHz. The IF and LO frequencies are so chosen that f IF LO .Ifthe image frequency f  c must fall outside of

Q. Comment brie?y on the following: (a) Why are waveguides not used at low frequencies? (b) Why are open-wire lines not generally used as guiding structures at very high freq

Analogue Threshold switching a) Include a variable potential divider to the schematic diagram to control the transistor base voltage b) Include the potential divider compon

I have all my report about Vehicle suspension systems . But I need the simulation and hardware test for this project. I need you to do it and give me the observation.

a cast steel has minimun diameter of 200 mm and a cross sectional area of 250/1000000 m . calclate the mmf to produce a flux of300/1000000 Wb.

Q. Explain the theory of thermal runaway?           The maximum average power Pdmax which a transistor can dissipate depends upon the transistor construction and may lie in the

What are procedures? Procedures are a group of instructions stored as a separate program in memory and it is known from the main program whenever needed. The type of procedure

why we use delay line in CRO what happens if we not use it?

(a) A wye-connected generator is to be designed to supply a 20-kV three-phase line. Find the terminal line-to-neutral voltage of each phase winding. (b) If the windings of the g

What is the impedance Z between terminals A and B of the networks shown below? Express your answers in polar form. Three voltages represented by v 1 (t)=100cosωt, v 2 (t)=7