Give the alternate functions for the port pins of port3, Electrical Engineering

Assignment Help:

Give the alternate functions for the port pins of port3?

RD - Read data control output.

WR - Write data control output.

T1 - Timer / Counter1 external input or test pin.

T0 - Timer / Counter0 external input or test pin.

INT1- Interrupt 1 input pin.

INT 0 - Interrupt 0 input pin.

TXD - Transmit data pin for serial port in UART mode.

RXD - Receive data pin for serial port in UART mode

 


Related Discussions:- Give the alternate functions for the port pins of port3

Determine the capacitance length of a pcb embedded stripline, 1. Determine ...

1. Determine the capacitance length of a PCB embedded stripline, assuming no fringing of the electrostatic field. 2. Determine the capacitance/unit length of the same embedded stri

Illustrate procedure of hex to binary conversion, Q. Illustrate procedure o...

Q. Illustrate procedure of Hex to Binary Conversion? It is also simple to convert from an integer hex number to binary. This is achieved by: Convert the Hex number t

Relative and absolute motion measuring device, a) With the help of a neat a...

a) With the help of a neat and clean sketch illustrate the difference between relative and absolute motion measuring device. b) Discuss electromechanical methods for calculating

Determine the peak frequency deviation, If an FM signal is given by s FM (t...

If an FM signal is given by s FM (t) = 100 cos [2πf c t +100 m(τ ) dτ ] and m(t) is given in figure, sketch the instantaneous frequency as a function of time and determine the pea

Performance equations of three phase induction motor , Performance Equation...

Performance Equations of Three Phase Induction Motor When balanced 3-? voltages are applied to the  stator  winding  a rotating magnetic field  of constant amplitude is produc

Show how emitter amplifier work as a buffer amplifier, Q. Due to what speci...

Q. Due to what special property does an emitter amplifier work as a buffer amplifier?  The circuit design of the emitter follower is such that it has a high input impedance and

Active filter design, Design a wide band pass filter with cut-off frequency...

Design a wide band pass filter with cut-off frequency f L = 400 kHz, f H = 600 kHz, and a pass-band gain = 10. The roll-off rate at the cut-off frequency should be at least 4

What are the hardware elements in the embedded systems, What are the hardwa...

What are the hardware elements in the embedded systems? Hardware Elements in the Embedded Systems are as follows: (i) Power Source (ii) Clock Oscillator Circuit and Clock

What is the per-unit slip at full load, Q. A three-phase, 60-Hz induction m...

Q. A three-phase, 60-Hz induction motor runs at almost 1800 r/min at no load, and at 1710 r/min at full load. (a) How many poles does the motor have? (b) What is the per-unit

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd