Geometric design of roads, Civil Engineering

Geometric Design Of Roads:

Geometric design of roads deals with elements such as cross-section, horizontal and vertical alignment, sight distances, lateral and vertical clearances and intersections.

Geometric design standards are influenced by:

(a)        Terrain of the road,

(b)       Design speed adopted, and

(c)        Class of the road.

Posted Date: 1/22/2013 2:29:54 AM | Location : United States







Related Discussions:- Geometric design of roads, Assignment Help, Ask Question on Geometric design of roads, Get Answer, Expert's Help, Geometric design of roads Discussions

Write discussion on Geometric design of roads
Your posts are moderated
Related Questions
find out the interior angleS with diagrame LINE AB, BC, CD, DE, EA Fore bearing 60''30" , 122'' , 46'' , 205''30" , 300''

Q. Why we use Air Valves? Air Valves - Air valves of proper size and pressure rating at summits. Air valves ensure the safety of the pipe line against collapse when at points o

Determine the normal and shear stress elements: The state of stress at a point is given through the stress components σ x = 70 MPa, σ y = 10 MPa, and τ xy = - 40 MPa. Using

difference between RCC and RBC

A piece of clay taken from a sampling tube has a wet weight of 1.553 N and volume of 95.3 cm 3 . After drying in an oven for 24 hours at 105°C, its weight 1.087 N. Suppose the spec

Most of the existing rubber dams are of air-filled types. Water-filled rubber dams aren't preferred for the below reasons: (i)  By giving same sheet length and dam height, tensi

What would be the best way to evaluate the field performance benefits of subsurface drainage in a flexible pavement? Short term and long term, thick or thin HMA..

Explain the term - Moderate Prestressing In this form of prestressing, no limit is imposed on  the magnitude of tensile stresses which may be produced in a concrete member unde


PART - A 1.  Can you enumerate the benefits of individual wall method of estimation? 2.  Estimate the single room of size  3m x 4m x height 3m  using individual wall method?