ENGINEERNING DRAWNING, Mechanical Engineering

HOW TO PREPARE A DRAWING IN FIRST ANGLE PROJECTION AND THIRD ANGLE PROJECTION AND WHAT IS THEIR BASIC PRINCIPLE AND WE DO NOT MAKE DRAWING IN 2ND ANGLE PROJECTION AND 4TH ANGLE PROJECTION
Posted Date: 4/21/2015 4:04:43 AM | Location : USA







Related Discussions:- ENGINEERNING DRAWNING, Assignment Help, Ask Question on ENGINEERNING DRAWNING, Get Answer, Expert's Help, ENGINEERNING DRAWNING Discussions

Write discussion on ENGINEERNING DRAWNING
Your posts are moderated
Related Questions
A powered metal-working crank press (a generic press is shown at the end) has been designed to be capable of punching blanks from mild steel sheet up to 3 mm thick. 1. the ultim

Answers all questions i. Illustrate Zeroth law of thermodynamics. ii. A gas contained in a cylinder is compressed, the work neede for compression being 5000 KJ. During the pr

Autocad screen- The autocad Screen basic chapter of Autocad course it will show the display of Autocad on computer screen

Evaluate resultant of the system: Q: Figure given below shows two vertical forces and couple of moment 2000 Nm acts on horizontal rod, which is fixed at end A .  Determin

Q. Explain about Master Stick File? The Master Stick File is an up-to-date version of the P&IDs; it is not to be used as a check print by any discipline. Miscellaneous comment

Explain End Relief Angle It is the angle between the plane perpendicular to base and end flank. The angle prevent\s the cutting tool from rubbing against the job where as if th

This section shall apply to the general requirements for design, fabrication, erection, and testing of structural steels for supports, stairways, ladders and platforms. All stru

what is the velocity and acceleration when connecting rod and crank are mutually perpendicular?

a) Determine a root of the equation x-cosx =0 using Bisection method correct to three decimal places. b) Determine smallest possible root of the equations x-e -x =0 using Regul

Q. Illustrate about Plant Type and Process? Plant layout is influenced by the type of plant (both the industry and technology utilized) and the kind of process units and associ