Engine oil level and viscosity, Mechanical Engineering

Engine oil level and viscosity : Ensure that the engine oil level is maintained till the upper mark on the gauge oil level. Check engine oil viscosity. Oil should not be abnormally thick.

2253_engine oil level and viscosity.png

Posted Date: 4/22/2013 2:44:52 AM | Location : United States







Related Discussions:- Engine oil level and viscosity, Assignment Help, Ask Question on Engine oil level and viscosity, Get Answer, Expert's Help, Engine oil level and viscosity Discussions

Write discussion on Engine oil level and viscosity
Your posts are moderated
Related Questions
Conve r t following reading of pressure to kPa, supposing that the barometer reads 760mm Hg. (1) 90cm Hg gauge (2) 40cm Hg vacuum (3) 1.2m H 2 O gauge Sol: Given

Keywords: Degree of Curve      :            The angle subtended at the centre by a chord of 100 ft (30.5 m) length. Super-elevation (cant)        :            The raising

Plastic material and rigid plastic material: For the plastic material, there is stress at which plastic deformation begins. A rigid plastic material is one in which the ela

If a Laboratory experiment, the following data were recorded with rope Break dynamometer : Diameter of fly-wheel = 1.2 m Diameter of the rope = 12.5 mm Speed = 200 r.p.m.

Determine the stresses in the shell: A cylindrical boiler is 2.5 m in diameter and 20 mm in thickness and it carries steam at a pressure of 1.0 N/mm2. Determine the stresses i

A Spring - mass system which is subjected to a harmonic force FCoswt. calculate the response of the system, refer figure Given x (0) = 0.01 m x(0) = 0.04 m/sec w = 30 rad/

Q. Leak Repair Torquing Procedure? Attempt to tighten only the bolts contained within an arc that includes the leak area plus one or two bolts either side of the leak to the or

Q. Process of Alloy Materials Sampling? The following alloy-materials require a minimum of 10% per lot representative PMI sampling. If any incorrect material is found in repres

Hinged Support: Hinged (Pin) Support: At hinged end, beam cannot move in any direction support will not develop any resisting moment, but it can develop reaction in any of t

Crankcase: It is connected to engine cylinder. It splits into two parts, named as right crankcase and left crank case. It supports the kick-starter spindle, crankshaft, main shaf