downsampling in dsp, Electrical Engineering

Assignment Help:
#ques1. (MATLAB) Generate 100 samples of the signal  = sin (0.125). We want to decimate this
signal using D = 2.
• Design a 25-order lowpass filter using the Parks-McClellan algorithm. Choose the
appropriate band-edge frequencies and equal ripple values to obtain h.
• Implement the decimator using function filter. Plot and the steady-state values of
the outputtion..

Related Discussions:- downsampling in dsp

Determine the dielectric constant of slab, Determine the Dielectric constan...

Determine the Dielectric constant of slab: An air capacitor contains two parallel plates 10 cm 2 in area and 0.5 cm apart. While a dielectric slab of area 10 cm2 and thicknes

Sbb instruction , SBB Instruction This  instruction is used to subtrac...

SBB Instruction This  instruction is used to subtract the contents of register  or memory  location  with carry  flag from accumulation. The results  of operations is stored

Mention the categories of instruction, Mention the categories of instructio...

Mention the categories of instruction and give two examples for each category The instructions of 8085 can be categorized into the following five Data transfer MOV Rd,Rs

Illumination, Ask question #Minimum 100A light assembly shop, 15 m long, 9 ...

Ask question #Minimum 100A light assembly shop, 15 m long, 9 m wide and 3 m up to trusses is to illuminated to a level of 200 lux. The utilization and maintenance factors are resp

Circuit realization of the srff, Q. You are to construct a modified truth t...

Q. You are to construct a modified truth table for the circuit realization of the SRFF shown in Figure. As indicated in the text, you guess an output and then go back ato check it

Commutator, explan Two segment and four sagment commutator action

explan Two segment and four sagment commutator action

Thermodynamices, How to prove that heat and work is a patha function?

How to prove that heat and work is a patha function?

Introduction to electronics, Explain the difference between a microprocesso...

Explain the difference between a microprocessor and an embedded microcontroller

Electrical and electronic principles, 12. A capacitor is to be constructed ...

12. A capacitor is to be constructed so that its capacitance is 0.2µF and to take a p.d. of 1.25kV across its terminals. The dielectric is to be mica which, after allowing a safety

Calculate minimum number of poles for the induction machine, A wound-rotor ...

A wound-rotor induction machine, driven by a dc motor whose speed can be controlled, is operated as a frequency changer. The three-phase stator winding of the induction machine is

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd