Determine the low-pass filter and amplitude spectra, Electrical Engineering

Assignment Help:

Q. Let a square-wave voltage source having an amplitude of 5V, a frequency of 1 kHz, a pulse width of 0.5 ms, and an internal source resistance of 50  be applied to a resistive load of 100. A filter (inductance L) is inserted between source and load in order to reduce all the high-frequency components above 5 kHz. Determine (a) L of the low-pass filter, (b) amplitude spectra of VL and VS, and (c) vL(t).


Related Discussions:- Determine the low-pass filter and amplitude spectra

Explain working of single-phase induction motors, Q. Explain working of Sin...

Q. Explain working of Single-Phase Induction Motors? For reasons of simplicity and cost, a single-phase power supply is universally preferred for fractional-horsepower motors.

1- phase full bridge inverter with r- load , 1- phase  Full Bridge Invert...

1- phase  Full Bridge Inverter with R- Load 1-phase full  bridge inverter with resistive load R i it has  advantage over 1-? half  bridge  inverter that it does  not require

Explain keyboard interfacing to 8088 through 8279, Explain keyboard interfa...

Explain keyboard interfacing to 8088 through 8279 . The 8279 is a programmable keyboard and display interfacing component which scans and encodes up to a 64-key keyboard and con

Show step-motor control system, Q. Show Step-motor control system? Figu...

Q. Show Step-motor control system? Figure illustrates a system in which the prime mover used in the disk-drive system is a step motor driven by pulse commands. In response to e

Diode transistor logic gate, A circuit realization of a NAND gate will now ...

A circuit realization of a NAND gate will now be developed. By connecting NAND gates together in various ways, one can synthesize other gates and flip-flops. Thus in principle, a s

Compute the current loss in the lines, Q. Consider a 240-V supply feeding a...

Q. Consider a 240-V supply feeding a resistive load of 10 kW through wires having a total resistance of R = 0.02 . For the same load, let a 120-V supply be used with a total wire

Jfet applications, how is it possible to operate Q3 with no dc drain? where...

how is it possible to operate Q3 with no dc drain? where is the dc operating point?

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd