Data copy operations, Electrical Engineering

Data Copy Operations

Instructions which  are used  to copy data from  one location to another  location kept in  this category. The location from  which data  is copied  is called source and the location  to which  data is  copied  destination. During  this copy  operation the  previous  contents of destination are overwritten without  modifying  the content s of the source

Important : No flags  are modified  by any  of the data copy  operation.

These instructions are used to copy data.

a.From  one register to another  register.

b.8/ 16 bit data directly  from the  instruction to any  register/ register pair.

c.Data from any register to memory.

d.Data from  memory  to any  register.

Posted Date: 4/4/2013 3:58:01 AM | Location : United States







Related Discussions:- Data copy operations, Assignment Help, Ask Question on Data copy operations, Get Answer, Expert's Help, Data copy operations Discussions

Write discussion on Data copy operations
Your posts are moderated
Related Questions
Explain pnp transistor circuit . pnp transistor: A transistor consist of  three terminals. In this pnp transistor there is two blocks of p- type semiconductors that are separa

Dielectric: Insulator that is used among the two plates of a capacitance is called as dielectric.  Electric field exists in the dielectric and the flux density depends on th

Bivector Meter As it is clear from the name provided 'Bivector', it records kWh and kVAh consumption along with maximum demand on both or on any one as needed. The working pri

Q. A four-pole dc generator is lap wound with 326 armature conductors. It runs at 650 r/min on full load, with an induced voltage of 252 V. If the bore of themachine is 42 cmin dia

Decision  Making The rhombus diamond symbol  is used to represent  the decision making  process  as shown  below.                                          Figure  De

Calculate the value of resistor: 1.  What are the significant differences in the way ammeters and voltmeters are connected. If an ammeter reads 2.5 A for a period of 4 minutes

How to build a 6 bit comparator?

Q. It is desired to cut a λ/4 length of RG58A/U cable (ε r = 2.3) at 150MHz.What is the physical length of this cable?

Unconditional Call Instruction CALL ( Unconditional Call) Instructions :This  instruction calls the subroutine program stored at memory  location specified  in the  instruction

Q. Sections construct in FORTAN? The sections construct is a no iterative work sharing construct which causes structured blocks to be shared among threads in team. Every struct