control system, Electrical Engineering

I need some help for doing the assignment
Posted Date: 4/4/2013 3:16:59 AM | Location : Canada







Related Discussions:- control system, Assignment Help, Ask Question on control system, Get Answer, Expert's Help, control system Discussions

Write discussion on control system
Your posts are moderated
Related Questions
I need some help for doing the assignment

One battery having of three cells in series. External resistance is 5 Ω E.m.f each cell is 1.5V and internal resistance is 0.2?. Measure the current flow and draw the circuit.

Assuming that the receiver sends a XOFF signal when the receive buffer is P% full in order to avoid any data or packet loss.

Question: a) For the circuits shown in figure a and in figure b, show the output voltage waveform V0(t) if a sinusoidal signal with peak value of 5V is applied and the dc suppl

Break over  voltage of Finger Voltage   The  minimum  forward voltage  when the gate  is opened  at which SCR  starts  conducting  heavily is called  the break over  voltage. To

Q. Illustrate Signal attenuation? Signal attenuation in many channels can be offset by using amplifiers to boost the signal level during transmission. However, the amplifier al

Q. Define the spectral resolution of satellite? Spectral resolution : The sensitivity to different features of earth is the most important aspects considered in the spectral

Turn off Time The time  interval  between  the instant when  the SCR  current  has  decreased to zero  after external  switching  of the SCR  voltage  circuit  and the  inst

3-phase 180 0 mode VSI In 1800 mode VSI  each thyristor  conduct  for 1800 and two  thyristor  are fired  at 600 interval. For  example  if thyristor  T1  is fired at 00 then

Semi-conductors have temperature coefficient of resistance.  (A) Negative                                    (B) Positive (C) Both positive and negative        (D) none o