having looked at the circuit, i first wanted to start my frequency from 0 and plot for 10000 to 20000. so in matlab i used f = 0:10000:20000; but the equation for frequency is f= 1/sqrt(2*pi*L1*C3). I wanted to know if it would make sense for me to use the formula in a subset called f0? and then use f0 because f is already defined?

Posted Date: 4/24/2013 7:54:57 PM | Location : Bahamas

Ask an Expert

Related Discussions:- clapp oscillator, Assignment Help, Ask Question on clapp oscillator, Get Answer, Expert's Help, clapp oscillator Discussions

Write discussion on clapp oscillator
Your posts are moderated

Write your message here..

Related Questions

Direct addressing , Direct Addressing In this  addressing  mode one  o... Direct Addressing In this  addressing  mode one  of the  operands is the  data stored  in the memory. The memory  address of the  operand is directly  given in the instruction

Determine the power angle delta, A synchronous motor has the following para... A synchronous motor has the following parameters per phase. E=2kv, Eo=5kv, X2=3ohms, and I=700amps. Draw the phasor diagram and determine (a) power angle delta, (b) active po

In what way is program control superior to wired control, Q. Classify switc... Q. Classify switching systems. In what way is stored program control superior to hard wired control? Ans: Classifications of switching systems are givenin block diagram belo

Robust, what''s robust? what''s robust?

Find out the low-frequency voltage gain, Design a differential amplifier wi... Design a differential amplifier with active current mirror load in Cadence using TSMC 0.35 micron process. The power supply voltage is 3.3V. A 10µA current reference is available

Binary to hexadecimal conversion, Binary  to Hexadecimal  Conversion ... Binary  to Hexadecimal  Conversion To convert a binary  number  into  hexadecimal  divide the number into group  of four  bits  each starting from the least significant bit. Th

What minimum value of coupling resistance, Q. It is desired to have a sag o... Q. It is desired to have a sag or tilt of no more than 10% when a 50Hz square wave is impressed on an amplifier stage. The output circuit resistance is Rv=1K. What minimum value of

Find the steady state values, Question: Consider the circuit shown in F... Question: Consider the circuit shown in Figure. There is no initial energy stored in the circuit until time t=0 when the switch is closed. (i) Transform the given circ

Chemical vapour deposition, Explain chemical vapour deposition method for t... Explain chemical vapour deposition method for the preparation of nanomaterial and its properties

Explain the modes of connection for polyphase transformers, Discuss the mod... Discuss the modes of connection for polyphase transformers Discuss with aid of electrical grouping and wiring connection diagrams the different types of connections for polypha