Advantages of unbonded post-tensioning systems, Civil Engineering

Assignment Help:

Advantages of unbonded post-tensioning systems

Similarly, some advantages of unbonded post-tensioning systems over bonded post-tensioning ones may be written as under :

 (a) The ability to individually adjust cables based on poor field conditions (For example: shifting a group of four cables around an opening by placing two to either side).

(b) The procedure of post-stress grouting is eliminated.

(c) The ability to de-stress the tendons before attempting repair work.

 


Related Discussions:- Advantages of unbonded post-tensioning systems

Haley''s formula in pile driving, Question What is major difference bet...

Question What is major difference between "hammer efficiency" and "coefficient of restitution" at what time using Haley's formula in pile driving?   Answer Hammer ef

Explain the design of waterway, Q. Explain the Design of waterway? When...

Q. Explain the Design of waterway? When the river flows between high banks and the whole width is actively functioning during high floods, the bridge waterway should practicall

Design the curtain to touch the seabed, Question For fixing of silt cur...

Question For fixing of silt curtains, what is the reason that it does not desirable to design the curtain to touch the seabed ? Answer Silt finished are resistant ve

General requirement for civil engineering, Question General requirement for...

Question General requirement for Civil Engineering Works in 1992 Edition, Clause 15.09 details that tying wires for strengthening adjacent to and above Class F4 and F5 closes must

Explain about the pot bearing - bridge bearing, Explain about the Pot Beari...

Explain about the Pot Bearing? POT bearing was developed in 1959 as an alternative to heavy steel sliding bearings. It consists of a circular non-reinforced rubber-pad fully en

Rectilinear motion, A train starts from rest as A and accelerates at 1,7m/...

A train starts from rest as A and accelerates at 1,7m/s2 to full speed at which it maintains until the brakes gives it a deceleration of 1,7m/s2 to stop at B. AB=1,6km. determine

Designing level of landings in piers, Question What is designing leve...

Question What is designing level of landings in piers? Answer Landings are designed as resting place for passengers throughout berthing and deserting of vessels. I

School building, from surveying to school building finish

from surveying to school building finish

Measurement of cement and aggregates, Measurement of cement and aggregates ...

Measurement of cement and aggregates - by weight vs. by volume Measurement of constituents for concrete is usually carried out by weight since of the following reasons: (i)

Strain due to bending, Beam of arbitrary cross-sectionsubjected to couples ...

Beam of arbitrary cross-sectionsubjected to couples M Bending moment at any sectionis M Consider segment of beam subtended by angle θ Some fibres will shorten e.g. ABand o

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd