Adi add immediate instruction , Electrical Engineering

ADI Add Immediate  Instruction

The  bit  data specified in the instruction  is  directly  added with  contents of accumulator and result  of operation is stored  in the  accumulator after addition. The  instruction format is

ADI 8 bit  data    ( A- A+ (8 bit data )]

Flags: All flags are modified  according to the results .

Posted Date: 4/4/2013 6:20:24 AM | Location : United States







Related Discussions:- Adi add immediate instruction , Assignment Help, Ask Question on Adi add immediate instruction , Get Answer, Expert's Help, Adi add immediate instruction Discussions

Write discussion on Adi add immediate instruction
Your posts are moderated
Related Questions

Flicker noise: I’d like to plot the graph of the flicker noise found in the data sheet for the amplifier (will be provided later) and also generate the equation for that graph sho

Q. Explain a common emitter configuration without a feedback. A simple common emitter transistor amplifier--having no negative feedback--is not an ideal amplifier. This is beca

Determine whether the diode (considered to be ideal) in the circuit of Figure (a) is conducting.

If the message has a spectrum where K and Wf are positive constants, sketch the spectrum of a standard AM signal that uses the message. Comment on the physical signi?cance

Explain Fourth group of 32 ASCII character code? The fourth, and final, group of 32 ASCII character codes are set aside for the lower case alphabetic symbols, five additional

a) Get the best linear relationship in accordance with least square analysis for the following data:- X 0.9 2.3 3.3 4.5 5.7 6.7 Y 1.1 1.6 2.6 3.2 4.0 5.0 b) The table belo

Q. A transformer has its maximum efficiency of 0.9800 when it delivers 15 kVA at unity power factor. During the day it is loaded as follows: 12 hours 2 kW at power factor 0.5

Operation of heterodyne wave analyzer with block diagram

Illustrate how to replace the HT Fuse on a 6-pole and 4-pole structure? Ans: a) Open switch on 6-pole or 4-pole. b) Connect the discharge rod between earth and conduc