About Transfer Function block, Mechanical Engineering

How can i change the normal function block parameter[1 1]=>(s+1) to (s-1)?
Posted Date: 10/23/2012 3:36:34 PM | Location : United States







Related Discussions:- About Transfer Function block, Assignment Help, Ask Question on About Transfer Function block, Get Answer, Expert's Help, About Transfer Function block Discussions

Write discussion on About Transfer Function block
Your posts are moderated
Related Questions
Q. Flange Bevel And Lap Ring Weld? The fillet weld attaching the lap ring to the shell shall be an equal leg fillet weld, with the leg dimension equal to the nominal shell thic

An inside cylinder locomotive has its cylinder centre lines 0.70m apart and has a stroke of 0.60m. Rotating mass per cylinder = 150kg Distance between wheel Centre lines = 1.

Illustrates about the need for reinforcement? NEED FOR REINFORCEMENT Concrete is economical and durable and is currently universally utilized for footings. Plain concrete is

Axis Perpendicular to the Vertical Plane - square prism: Here a square prism, side of base 40 millimeter and axis 60 millimeter long is resting on the HP on its base along wit

STEA M ENGINE TERMINOLOGY: 1 .     Cylinder Bore: Inside diameter of cylinder. 2 .     Cover End and Crank End of cylinder: In the horizontal cylinders the end that

Q. Design Ventilation Systems for plant? While some natural ventilation may sometimes be used, a pressurized HVAC (heating, ventilation and air-conditioning) system is more typ

The Radius Dimension Command The Radius command is quite identical to the Diameter command except that the dimension measurements a radius rather than a dimension and the resul


explicate desalinationm techniques of water by using different memberanes