reversible and irreversible, Mechanical Engineering

Assignment Help:
state a note on reversible and irreversible process?

Related Discussions:- reversible and irreversible

Shielded metal arc welding, Shielded Metal Arc Welding   Single pass...

Shielded Metal Arc Welding   Single pass fillet welds upto ¼" (6.4 mm) maximum and ¼" groove welds made with a single pass or a single pass each side, may be made by using a

Write down the uses of vernier caliper and steel rule tools, Write down the...

Write down the uses of following tools and make neat sketches of the same : (a) Vernier Caliper (b) Steel Rule

Illustrate the importance of aesthetic consideration, You as design Enginee...

You as design Engineer, Describe how you would decide a suitable factor of safety for the design of a new mechanical elements. Illustrate the importance of aesthetic considerati

Pelton wheel, An axial flow pump handling oil of specific gravity 0.8 at a ...

An axial flow pump handling oil of specific gravity 0.8 at a rate of 1.0m3 s-1 is fitted with downstream guide vanes and its impeller rotates at 250 rev min-1. The oil approaches t

Tolerances, difference between geometric and amnufacturing tolerances

difference between geometric and amnufacturing tolerances

Method of section, Figure shows a Warren girder consisting of seven members...

Figure shows a Warren girder consisting of seven members each of 3 m length freely supported at its end points. The girder is loaded at B and C as given. Determine the forces in al

Determine the thermal efficiency, A combined cycle plant is designed to dev...

A combined cycle plant is designed to develop 200MW power. The air is obtained by the compressor at 300K and 1 bar pressure. The maximum temperature of the gas turbine cycle is lim

Spark plug -electrical system , Spark Plug: A spark jumps between the elec...

Spark Plug: A spark jumps between the electrodes of the spark plug when the voltage developed by the ignition system reaches the required value. This electrical spark occurs at a

Pyrolysis-manufacturing methods of ceramics, Pyrolysis Pyrolysis is th...

Pyrolysis Pyrolysis is the procedure of depositing a ceramic on a heated substrate. The process is used to deposit coating or generate thin walled components of graphite or si

Find speed of dynamo shaft, Find speed of dynamo shaft: Q: W ith the...

Find speed of dynamo shaft: Q: W ith the help of belt an engine running at 200rpm drives line shaft. The Diameter of the pulley on engine is 80cm and the diameter of the pul

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd