What is the maximum volume of treated wastewater

Assignment Help Civil Engineering
Reference no: EM13550440

Incoming wastewater , with BOD5 equal to about 200mg/l is treated in well-run secondery treatment plant remove 90 percent of the BOD. you are to run five-day BOD test with a stander 300-ml bottle , using mixture of treated sewage and dilution water(no seed) assume the intial DOis 9.2mg/l

A)roughly what is the maximum Volume of treated wastewater should you put in the bottle if you want to have at least 2.0mg/l of DO at the test (filling the rest of the bottle with the water

b) if you make mixture half water and half treated wastewater, what DO would you expect after five days?

Reference no: EM13550440

Questions Cloud

Determine the maximum compression of the spring mounted : The 30-Mg freight car A and 15-Mg freight car B are moving toward each other with the velocities VA= 20 km/h to the right and VB= 10 km/h to the left. the spring constant on car A is k= 3MN/m.
Calculate the couple c a that must be supplied by the : The table lamp consists of two uniform arms, each weighing 0.8 lb, and a 2-lb bulb fixture. If ? = 16? , calculate the couple C A that must be supplied by the friction in joint A.
Determine which of the following statements is true : The velocity and pressure are given at two points in the flow field. Assume that the two points lie in a horizontal plane and that the fluid density is uniform in the flow field and is equal to 1000 kg/m^3. assume steady flow. Then, given these data,..
What are the spcs83 coordinates and convergence angle : What are the SPCS83 coordinates and convergence angle for a station in the Colorado Central zone with geodetic coordinates of 39° 44’ 40.74141”N, 105° 00’ 07.48466”W
What is the maximum volume of treated wastewater : Roughly what is the maximum Volume of treated wastewater should you put in the bottle if you want to have at least 2.0mg/l of DO at the test (filling the rest of the bottle with the water
What is the scale of the model in terms of the prototype : A maximum flow rate of 6 CFS is available for a river model. This corresponds to 30,000 CFS for the prototype. What is the scale of the model in terms of the prototype size?
The basin dimensions if increments of 1.0 inch are used : A rapid-mixing basin is to be designed for a water coagulation plant, and the design flow for the basin is 4.0 MGD (million gallons per day). The basin is to be square with a depth equal to 1.25 times the width.
Determine by trigonometry the magnitude and direction : Two parallel disks of diameter D are brought together, each with a normal speed of V. when their spacing is h, what is the radial component of convective acceleration at the section just inside the edge of the disk (section A) in terms of D, V, and h..
You are paying into a mututal fund that earns compound : You are paying into a mututal fund that earns 6% compound interest. If you are making an annual contribution of $10000, how much will be in the funds in 20 years? What if the fund makes 10%? What if it loses 5% per year?

Reviews

Write a Review

Civil Engineering Questions & Answers

  What is the elevation of point n

A leveling rod is held vertically on another point N. When a sight is taken on the rod, the telescope is inclined so that the horizontal cross line of the transit intersects the rod at a reading of 4.9 ft.

  Determine the height of capillary rise to smooth glass

Plot the distribution of vertical effective stress and porewater pressure with depth if the void ratio of the sand is 0.6 and the degree of saturation is 90%. Neglect pore air pressure

  What is the true air speed

Given that an aircraft flying at FL350 encounters a tailwindof 35 knots and the instrument in the cockpit shows anindicated airspeed of 310 knots. What is the standard atmosphere atthis altitude?

  Write out the steps for the aldol condensation reaction

Write out the steps for the aldol condensation reaction between the enolate anion of propanal with pentanal.

  What is the left turn adjustment factor for the case describ

An intersection approach has three lanes, permitted left turns, and 6% left-turning volume with a through vehicle equivalent of 5.0 tvu/left turn. The saturation flow rate for through vehicles under prevailing conditions is 1,700 veh/hg/ln.

  Will the population reach 10000 before the year 2100

A very small country has just gained independence in the year 2000, at which time its population was 1,000. The new country has a birth rate of 0.02 yr-1, death rate of 0.004 yr-1, immigration rate of 0.01 yr-1, and emigration rate of 0.005 yr-1.

  Explain online professor''s response to probability problems

Online professor's response to: Probability problems, A very rich investor has a small amount of spare cash which she wishes to invest. She has four options to choose from.

  What will be the uniform load so to get the maximum

If a W14x53 is 20 ft long (simply supported) and is loadeduniformly to its moment capacity what is the maximumdeflection? What will be the uniform load so to get the maximum deflection?

  Determine the pressure variation in the flow field

A plane flow field is developed by addition of a free vortex and a uniform stream in the positive x direction. If the vortex is located a distance a from the origin, find the pressure variation in the flow field.

  Calculate horizontal scale factor and effective conductivity

It is proposed to estimate the seepage flow rate through the foundation soil using the flow net sketching technique. For this purpose, calculate the horizontal scale factor and effective hydraulic conductivity of the foundation soil.

  Determine what is the effluent bod concentration

An activated sludge tank, 30 x 30 x 200 ft, is designed as a plug-flow reactor, with an influent BOD of 200 mg/L and a flow rate of 1 million gallons per day. a. If BOD removal is first-order reaction, and the rate constant is 2.5 days^-1, what is ..

  Develop an equation for a safe minimum design radius r

The speed limit for a highway is given as "V" in mph. The highway super elevation is given as "e" in ft/ft. The friction between tires and wet pavement is given as "f".

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd