Simulate the network using netml

Assignment Help Computer Networking
Reference no: EM1373133

The link capacities are all 10 Mbps except for the middle link, which has capacity 2 Mbps. The top traffic stream and bottom traffic stream are both bulk ftp transfers of 10 Mbytes and the other traffic stream is a UDP flow of 100000 packets with an interval between packets of 0.1 second.

The issue we wish to explore in this problem is whether a traffic flow can be disadvantaged by passing along a path with larger propagation delay than the other flows which share the network.

In addition, we would like to explore ways in which this performance problem (if it exists) might be alleviated. The methods we wish to explore as follows:

• replace the default DropTail queue at the congested node, X, by a RED queue;

• try different values of the propagation delay from Z to X starting at 50ms and going up to 500ms (including at least, 100ms), to see if the problem becomes more serious with delay (and less serious as the delay differential decreases);

• check if the problem is different depending on which of the two flows (the one with a long delay and the one with a short delay) starts first.

Network Setup

All the links in the network should have a data rate of 10 Mbps and a propagation delay of 10 ms except the link from X to Y, which should have a data rate of 2 Mbps, and the link from Z to X, which should have a propagation delay of 50ms initially, and then varying up to 500 ms.

The top and bottom traffic flows should be ftp transfers of 10,000,000 bytes each. The one at the top should start at 1s, and the one below at 4s (although this will be varied during the experiments). Both flows should have a finish time of 10s and the PacketSize parameter of both should be 1000. The other traffic stream should be a UDP Ping flow, with an Interval of 0.1, starting at time 0.9s, and finishing at time 10 and with many packets: 100,000.

The criteria for this assignment are as follows:

Aspect 1
A satisfactory assignment document has been prepared; a network has been created and is depicted in a diagram in the assignment document.

Aspect 2
Graphs which explain the behavior of the network in its original setup are presented including the throughput of the three flows.

Aspect 3
Graphs of dropped packets, and the congestion window between A and B and between Z and F, are included.

Aspect 4
A description of the normal behavior of the network is included in the assignment document. This should include a comparison of the throughput of the flow with a long delay to the flow with a short delay.

Aspect 5
A description of the behavior of the network when the DropTail queue is replaced by a RED queue is provided. This should include plots of key performance indicators such as throughput for both FTP flows.

Aspect 6
Experiments have been conducted to determine the effect of the delay difference (increasing the delay from 50ms to 500ms), between the two ftp flows, on the different performance each flow experiences.

Aspect 7
Experiments have been conducted to show if it makes a difference if the flow from A to B starts before or after the flow from Z to F.

Aspect 8
The assignment includes a discussion section in which the issue of fair access to network resources by flows with different path lengths and different start times is discussed.

1418_Simulate the network using netml.png

Reference no: EM1373133

Identify at least one disadvantage of using each topology

Wireless communication, generally, useless three configuration topologies (1) point to point; (2) point to multipoint; and (3) multi-point to point. In this paper, (a) defi

Defines minimum packet size network technology to allow ip

Although not explicity stated, the Internet Protocol(IP) specification,RFC 791, defines the minimum packet size a network technology must support to allow IP to run over

Write own connectionless udp client

USC EECS450 - Write your own connectionless (UDP) client. Print out everything - Send a UDP packet to DNS.POSTEL.ORG on port 60450, from your server IP address and port numb

What is the function of inverse multiplexing

What is the function of inverse multiplexing (IMUX)? If you were buying a multiplexer, why would you choose either TDM or FDM? Why?- Some experts argue that modems may soon

Find ip subnet mask and gateway-choosing unused address

After choosing unused address from the range given in d for the IP address for a device on the LAN, what would the IP subnet mask and gateway be set to? Explain why these

How the web user interfaces help donors to make decisions

Explain how the Web user interfaces help donors to make decisions and relate the emotional thread demonstrated in the case study to the emotional design model as discussed in

Different it systems

identify five different IT systems that have affected business in the past few years (i.e., business software applications, networks, hardware, internet-based technologies,

Describe the features and benefits of csma-cd

For the purposes of this question you do not need to know about the token access method. You just want to explain the features and benefits of CSMA/CD.

Reviews

Write a Review

 
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd