Determine the horizontal component of the average impulsive

Assignment Help Civil Engineering
Reference no: EM13539183

The last segment of the triple jump tracxk and feild event is the jump, in which the athlete makes a final leap, landing in a sand filled pit. Assuming that the velcity of a 185 lb athlete just before landing is 30 ft/s at an angle of 35 degrees with the horizontal and that the athlete comes to a complete stop in .22 seconds after landing, determine the horizontal component of the average impulsive force exerted on his feet during landing?

Reference no: EM13539183

Questions Cloud

A line in the x-ray spectrum of gold has a wavelength : A line in the x-ray spectrum of gold has a wavelength of 18.5 pm(=18.5x10^-12 m) The emitted x-ray photons corresponds to a transition of the gold atom between two stationary states, the upper one of which has the energy -13.7 keV. What is the ene..
Electron in the ground state of a hydrogen atom : Calculate the probability that an electron in the ground state of a hydrogen atom will be found at a greater distance from the nucleus than would be allowed classically.
What is the photoelectric cut-off wavelength : The work function for cesium, 1.81 eV, is much lower than the work function for other metals. What is the photoelectric cut-off wavelength? What is the maximum electron kinetic energy when cesium is illuminated with light of 512-nm wavelength?
What will the wires resistance be if it is stretched to : A wire has a resistance of 1.2×10-2 . What will the wire's resistance be if it is stretched to twice its original length without changing the volume of the wire?
Determine the horizontal component of the average impulsive : The last segment of the triple jump tracxk and feild event is the jump, in which the athlete makes a final leap, landing in a sand filled pit. Assuming that the velcity of a 185 lb athlete just before landing is 30 ft/s at an angle of 35 degrees with..
Determine the maximum additional deformation of the spring : A spring is used to stop a 50 kg package which is moving down a 20 degree incline. the spring has a constant of 30kN/m and is held by cables so that it is initally compressed 50mm
A static thrust stand is to be designed for testing : A static thrust stand is to be designed for testing a specific jet engine. Knowing the following conditions for a typical test,
What should the alternative hypothesis be : One poll found that 46% of male voters will support a candidate while another found that 49% of female voters will be in support. To test whether this candidate has equal levels of support between male and female voters, what should the alternative h..
How large a sample is needed to estimate the true proportion : A report states that 42% of home owners had a vegetable garden.  How large a sample is needed to estimate the true proportion of home owners who have vegetable gardens to within 5% with 98% confidence?

Reviews

Write a Review

Civil Engineering Questions & Answers

  What is the pressure drop per unit length along the tube

It is known that the velocity distribution for steady, laminar flowin circular tubes (either horizontal od vertical) isparabolic. Consider a 10 -mm- diameter horizontal tubethrough with ethyl alcohol is flowing with a steady mean velocity.15 m/s.

  Calculate the surface area required for a stabilization pond

Calculate the surface area required for a stabilization pond to serve a domestic population of 1000. Assume 80 gpcd at 210 mg/l of BOD. Use a design loading of 20 lb of BOD/acre/day.

  A 250-g sample of a large biomolecule was dissolved in 250

a 2.50-g sample of a large biomolecule was dissolved in 25.0 g of carbon tetrachloride. the boiling point of this

  What was involved in the first far-reaching

what was involved in the first far-reaching, comprehensive study of Earth's oceans?

  How much benzene can be optimally removed by the gac filter

A municipal water supply became contaminated with benzene (Cw=50g/L). It was decided that until the contaminant source could be identified and remediated, all household faucets would be fitted with a granular activated carbon(GAC) filter bed to ad..

  Determine what is the intrinsic permeability of coarse sand

The hydraulic conductivity of a coarse sand was measured in the laboratory permeameter and found to be 1.03x10^-2 cm/s at 25 degrees C. What is the intrinsic permeability

  Determine the stresses in the steel and concrete

determine the stresses in the steel and concrete under the service loads

  Determine what will be the discharge q at a depth

If sewage (assume the properties are the same as those of water) flows at a depth of 1.5ft in the pipe, what will be the discharge Q = 10.6 cubic feet/second

  Determine the time it takes to break the cord

A 3 kg mass is attached to one end of a 1 m long cord. The other end of the cord is attached to the center of a rotating disk (with radius greater than 1 m) that has a very large constant angular velocity.

  Determine te maximum normal stress in the container

A spherical gas container made of steel has a 5-m outer diameter and a wall thickness of 6 mm. Knowing the internal pressure is 350 kPa, determine te maximum normal stress and the maximum shearing stress in the container.

  Determine the deflection in degree for horizontal wind speed

Determine the deflection in degrees for horizontal wind speed of 10m/s and what is the magnitude of the force required at the bottom of the sign to prevent the sign from deflecting

  Determine the worked deeloped in kj per kg of air

air enters a turbine operating at steady state at 8 bar, 1127 C and exits at 1.5 bar, 347 C. The heat transfer from the turbine to its surroundings is 10 kJ/kg of air flowing through the turbine.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd