### Construct the shearing force and bending moment diagrams

Assignment Help Mechanical Engineering
##### Reference no: EM13835643

A cantilever 5 m long carries a uniformly distributed vertical load 480 N per metre from C from H, and a concentrated vertical load of 1000 N at its midlength, D. Construct the shearing force and bending moment diagrams.

#### An air compressor is designed to compress ambient

An air compressor is designed to compress ambient (assumed to be 100 kPa, 20C) to a pressure 1 MPa. The heat transfer rate to the ambient is anticipated to be equal to 10% of

#### Determine the stress in the stay at this temperature

Assume zero stress in the stay on completion of fitting. when the temperature falls to -10 degrees centigrade, the gap between the walls is reduced by 0.5mm. Determine the s

#### Compute vector magnetic potential within outer conductor

Compute the vector magnetic potential within the outer conductor for the coaxial line whose vector magnetic potential is shown in Figure 7.20 if the outer radius of the oute

#### Determine the electric power required by the heat pump

A heat pump with a coefficient of performance of 3.8 provides energy at an average rate of 75,000 kJ/h to maintain a building at 21oC on a day when the outside temperature is

#### Mixture is heated and expands at constant pressure

A piston-cylinder assembly contains a two-phase liquid-vapor mixture of H2O at 160 lbf/in.2 with a quality of 70%. The mixture is heated and expands at constant pressure until

#### Determine the mass ratio necessary to boost the vehicle

For a vehicle in gravitationless space, determine the mass ratio necessary to boost the vehicle velocity by 1600 m/sec; the effective exhaust velocity is 2000 m/sec and the

#### What will be the composition of the vapor stream

A compressed liquid mixture of 42 mol percent n-hexane (1) and 58 mol percent ethane (2) is to be fed to a flash tank where the pressure is reduced and a liquid and vapor stre

#### Volumetric analysis of a mixture of a mixture of gases

The volumetric analysis of a mixture of a mixture of gases is 30 percent oxygen, 40 percent nitrogen 10 percent dioxide, 20 percent methane. This mixture flows through a 1-in-