Calculate the amount of water to be added per cubic meter

Assignment Help Civil Engineering
Reference no: EM13296994

An undisturbed soil sample has a total unit weight of 19.4 kN/m3, a dry unit weight of 16.9 kN/m3, and a specific gravity of soil solids (Gs) of 2.69. Determine
(a) Void ratio (e)
(b) Porosity (n)
(c) Degree of saturation (S in %)

If the sample could be saturated without changing its porosity, calculate the amount of water (in kN) to be added per cubic meter of soil to achieve 100% saturation.

Reference no: EM13296994

Questions Cloud

What is the 2-4-6-trichlorophenol concentration in ppm : A 500 L (132 gal) tank contains 255 mg/L 2,4,6-trichlorophenol dissolved in trichloroethylene (TCE). What is the 2,4,6-trichlorophenol concentration in ppm Assume the temperature of the system is 20 degrees C.
What is the tce concentration in mg per cubic meter : The concentration of trichloroethelyne (TCE) in an air sample near a hazardous waste landfill is 34 ppm, the ambient air temperature is 31 degrees C, and the atmospheric pressure is 0.94 atm. What is the TCE concentration in mg/m^3
Determine what was the major principal stress at failure : A consolidated-drained triaxial test on a normally consolidated clay yielded a friction angle of 28°. If the all-round confining pressure during the test was 140 kN/m2, what was the major principal stress at failure.
What is your percentage return on equity for this trade : Suppose you are correct and the stock falls to $70.50 per share at the end of the year. What is your percentage return on equity for this trade?
Calculate the amount of water to be added per cubic meter : An undisturbed soil sample has a total unit weight of 19.4 kN/m3, a dry unit weight of 16.9 kN/m3, and a specific gravity of soil solids (Gs) of 2.69. If the sample could be saturated without changing its porosity, calculate the amount of water (i..
What is the implied value of each warrant : The current yield on similar straight bonds is 15%. What is the implied value of each warrant? (a) $3.76 (b) $3.94 (c) $4.14 (d) $4.35 (e) $4.56
What is the value of a share of stock : A firm paid a $3.00 dividend last year and dividends are expected to grow at 15% for the next 5 years and 5% thereafter. If the required return is 13%, what is the value of a share of stock?
Determine the speed of the impellers in rpm : The plant is to employ alum coagulation. and pertient data for the folcculation basin are as follows: detention time = 20 min, G = 35 /sec at 50F, GT = 10000 to 100000, width = 1.25 depth, length = 2width, no baffling, number of impellers = 2
Draw and submit a time line : Draw and submit a time line, including EBIT, taxes, depreciation, operating cash flow, tvm factors, and discounted cash flow.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Discharged of wastewater to aquifer

Wastewater is discharged into an aquifer. This wastewater contains 0.1 ppm atrazine (a common herbicide). The MCL of atrazine is 5 ppb, the density is 1.19 g/mL and the solubility is 50 ppm. 500 ft away from the plant effluent there is a permeable..

  Tackling the problem of making tunnel

You are a Project Manager on site where work for 3K.m. long Tunnel has been undertaken. The site is remote and takes about 2 days travel to nearest town. Supervisors, Technicians & Skilled Workers are engaged in dangerous / hazardous work.

  Determine the flow rate of the oil

Oil of a specific gravity of 0.75 is flowing through a 6-in pipe under a pressure of 15 psi. If the total energy relative to the datumplate is 8.0 ft below the center of the pipe is 58.6 ft, determine the flow rate of the oil.

  What are the main policy aspects of the clean water act

What are the major policy aspects of the Clean Water Act? What is the history and statutory basis for federal regulation of wetlands? What are the national permits? What are the origin and significance of the no net loss policy?

  Determine the void content

If the dry-rodded unit weight of an aggregate is 105 lb/ft3 (1680 kg/m3) and its specific gravity is 2.65, determine the void content.

  Draw elevation, plan and development of the lateral surfaces

Axis of the hole is perpendicular to VP. Draw elevation, plan and development of the lateral surfaces of the pyramid.

  Calculate the wet density in pounds per cubic feet

A small chunk of the original sample had a wet weight of 140.9 grams and weighed 85.2 grams after drying. Compute the water content, using the correct number of significant figures.

  Determine the smallest standard commercial pipe

For satisfactory operation, the static pressure at the pump inlet must not be lower than -6 m of water gage. Determine the smallest standard commercial pipe that will give the required performance.

  Determine both the point of tangent and deflection angles

The point of intersection of the tangents is located at station (948+67.32). If the design speed of the highway is 60mi/h, determine both the point of tangent and the deflection angles to whole stations for laying out the curve. Select appropriate..

  Determine the power that must be supplied

determine the power that must be supplied to the motor at this instant. The motor has an efficiency of 76 %. Neglect the mass of the pulleys and cables.

  Tightening of bolt in the friction grip

What difference does the tightening of bolt in the friction grip joint make to the load at first slip and the failure load.

  What should be the new volume of the lake

Suppose that the distance from the lake outlet to the withdrawal cannot be more than 20 mi. What should be the new volume of the lake?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd