Workshop disciplines for general safety, Mechanical Engineering

Assignment Help:

WORKSHOP DISCIPLINES

Following discipline tips should be made a part of life to become a good technician. These will certainly help in creating safe, friendly and clean environment.

Always wear fit and proper dress, use gloves and do not wear rings, chains, etc.
Always keep the workplace clean and tidy.
Always keep the things at their proper place.
Be careful and honest to your duty.
Follow the instructions of your superior.
Do not work on any machine, if you do not know its operations and other details.

Related Discussions:- Workshop disciplines for general safety

Pole-relative pole-accuracy points-freudenstein’s equation, Pole: this is...

Pole: this is the centre of finite rotation of the coupler. Relative Pole: this is the pole of coupler associated to other moving link. Accuracy Points: The points at w

Shm, How we say that motion of the follower is simple harmonic motion descr...

How we say that motion of the follower is simple harmonic motion describe in practical approch

Example of change of enthalpy, Example of change of enthalpy: Q 0.5...

Example of change of enthalpy: Q 0.5kg/s of a fluid flows in steady state process. The properties of fluid at the entrance are measured as p 1 = 1.4bar, density = 2.5k

Illustarte acceptance sampling and oc-curve, Illustarte the following (a...

Illustarte the following (a) Acceptance sampling (b) OC-Curve

Determine range of diameter of the copper core, A copper-silver bimetallic ...

A copper-silver bimetallic wire, 1 cm in diameter, is prepared by co-extrusion with copper as the core and silver as the outer layer. The desired properties along the axis parallel

Extrusion, Difference between hot extrusion and cold extrusion

Difference between hot extrusion and cold extrusion

Internal combustion engines, During a test on a Lister engine in a thermal ...

During a test on a Lister engine in a thermal laboratory, following parameters were measured; crank shaft speed=1,750rpm Load on dynamometer=220N Radius of dynamometer=1.5m Fuel co

Find out the angle of force - center of wheel, Find out the angle of force:...

Find out the angle of force: Q: A uniform wheel having 60 cm diameter weighing 1000 N rests against rectangular obstacle 15 cm high. Find least force required which when ac

Dom, what is offset inertia force

what is offset inertia force

Carnot theorem and efficiency - thermodynamics, Carno t Theorem: No h...

Carno t Theorem: No heat engine operating in cycle between the two given thermal reservoir, having fixed temperature can be more efficient than reversible engine operating be

Write Your Message!

Name

Email id

Message

Verfication Code

User Account

All Pages