Why we need paving in design of a plant, Mechanical Engineering

Assignment Help:

Q. Why we need paving in design of a plant?

Concrete paving should be provided under any equipment where flammable or hazardous liquids may be spilled during routine operation or maintenance activities. Regardless of what the surrounding ground cover is, at these critical locations concrete is to be used exclusively, with ground drainage to accommodate. This includes:

• To the outside edge of the supporting column piers of such equipment as bottom oil-fired or combustible-liquid-containing furnaces and elevated structures supporting coke drums, etc.

• Under pipe racks where low point draining, sampling or blinds insertion is frequently performed.

• Around catalyst-containing vessels.

• Around groups of two or more pumps located outdoors.

• Around compressors and their related servicing equipment (e.g. lube oil consoles).

• Around equipment in dirty service that requires frequent turnaround maintenance.

• Around loading facilities for flammable or hazardous liquids.


Related Discussions:- Why we need paving in design of a plant

Agriculture, i am thinking that neglecting the foot gears and put hand gear...

i am thinking that neglecting the foot gears and put hand gears instead of it in two wheelers .so what is the procedure

Elasticity, define prandtl''s stress function

define prandtl''s stress function

Explain the objectives of value engineering, OBJECTIVES OF VE: 1. To esta...

OBJECTIVES OF VE: 1. To establishing the monitoring value of the function of the product or services. 2. To identifying unnecessary cost or hidden cost in a product or services.

Direct and bending stress, a masonry pier 3m*4m supports vertical load of 6...

a masonry pier 3m*4m supports vertical load of 600kn at point (1.2,1),find stresses at corner of pier

What do you mean by preignition, Explain the autoignition and detonation th...

Explain the autoignition and detonation theory of detonation. What do you mean by preignition ? Describe octane Rating of a fuel. What are the different S.I. engine combustion cham

Homogeneous and isotropic material, Homogeneous and isotropic material: ...

Homogeneous and isotropic material: A homogeneous material implies that elastic properties like modulus of elasticity and Poisson's ratio of material are same everywhere in

Involutes, considerations for shape changers

considerations for shape changers

Air injection system and solid injection system, (a) Explain a typical fuel...

(a) Explain a typical fuel feed system for a C.I engine, differentiate between air injection system and solid injection system. (b) Why Gasoline injection system has been adopte

Welded pressure joint requirements, Q. Welded Pressure Joint Requirements? ...

Q. Welded Pressure Joint Requirements? The welded pressure joint requirements should be selected to be suitable to the need; however, the following shall apply: Welded joint

Determine the work done by the gas system, (a) Derive the mathematical equa...

(a) Derive the mathematical equation for work done in a polytropic process (i.e.) PV n =c) (b) A mass of gas is compressed in a quasi-static process from 80KPa, 0.1m 3 to 0.4M

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd