Homogeneous and isotropic material, Mechanical Engineering

Assignment Help:

Homogeneous and isotropic material:

A homogeneous material implies that elastic properties like modulus of elasticity and Poisson's ratio of material are same everywhere in material system. Isotropic means that the properties are not directional characteristics, that is, an isotropic material has same elastic properties in all the directions at any one point of body:

 

 


Related Discussions:- Homogeneous and isotropic material

Maximum stress in each material, The maximum stress in each material: ...

The maximum stress in each material: A copper tube of external diameter 60 mm and internal diameter 40 mm is closely fitted to a steel rod of 40 mm diameter to compose a compo

10'''' flange horizontal offset allowable, How does the maximum the 10'''' ...

How does the maximum the 10'''' flange horizontal offset allowable.

Evaluate the actual over all efficiency of the turbine, (a) An engine uses ...

(a) An engine uses 6.5 Kg of oil per hr of a calorific value 30,000 kJ / kg. If the B. P. of the engine is 22KW and mechanical efficiency 85%. Calculate (i) Brake thermal eff

Evaluate piston effect, In a double acting vertical steam engine running at...

In a double acting vertical steam engine running at speed of 360 r.p.m., cylinder diameter is 25 cm, stroke is 30 cm, diameter of piston rod is about 3.75 cm and length of the conn

Estimate the rate of flow, At a sudden enlargement of a water main from 240...

At a sudden enlargement of a water main from 240 mm to 480 mm diameter, the hydraulic gradient rises by 10 mm. Estimate the rate of flow.

Specifications of hardness testing machines and indentors, Specification s...

Specification s of Hardness Testing Machines and Indentors: The Brinel cum Rockwell Tester has specifications which are stated below: Ability to determine the hardness up t

Evaluate the composite transformation matrix, A triangle ABC with vertices ...

A triangle ABC with vertices A (30,20), B(90,20), C(30,80) is to be scaled by a factor of 0.5 about a point X(50,40). Calculate :- (i) The composite transformation matrix; and

Explain tee joints, Tee joints -The square tee joint requires a fillet weld...

Tee joints -The square tee joint requires a fillet weld that can be made on one or both sides. It can be used for light or fairly thick materials. For maximum strength, considerabl

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd