Why is an emitter bypass capacitor in amplifier, Electrical Engineering

Assignment Help:

Q.  Why is an emitter bypass capacitor used in an RC coupled amplifier?

If an emitter resistor Re is used for self-bias in an amplifier and if it is desired to avoid the degeneration, and hence the loss of gain due to Re, we bypass this resistor with a very large capacitance .The effect of this capacitor is to affect adversely the low-frequency response.

It is used to avoid negative feedback.


Related Discussions:- Why is an emitter bypass capacitor in amplifier

Determine the expected voltage levels at the output, The subsequent voltage...

The subsequent voltage-source multiplying DAC is to be utilized to convert the digital data stream "11" and "01" to an analog signal.  It has 2-bit inputs and hence is capable of c

Construct the corresponding transfer function, Consider the following IIR f...

Consider the following IIR filter. The initial input data sequence is given by x n = [10 15 20 15 8 6 9 0 0 0] Construct a table that shows the corresponding signal values at

Solution manual, Ask question #Minimum 100 words accespted#i want solution ...

Ask question #Minimum 100 words accespted#i want solution manual of electronic instrumentation and measurements

Design a circuit using op-amp amplifier, Design a circuit using op-amp that...

Design a circuit using op-amp that will reject the 60kHz power line noise and also reject high signal frequency above 800Khz. The stop-band width around the 60kHz centre frequency

Sources of power dissipation in cmos logic, Describe the three main sources...

Describe the three main sources of power dissipation in CMOS logic. Hence calculate the power dissipated in a CMOS ASIC of 40,000 gates operating at a frequency of 133MHz with a s

Ac motors, If the stator windings of an alternator were to be supplied ...

If the stator windings of an alternator were to be supplied by an AC of frequency f (as opposed to drawing an AC current from them as would be the case for an alternator) then

Armature reaction, cross magnetizing components of armature reaction is.......

cross magnetizing components of armature reaction is...........

Show how a 16-to-1 multiplexer can be obtained, Q. Using two 8-to-1multiple...

Q. Using two 8-to-1multiplexers and one 2-to-1multiplexer, show how a 16-to-1 multiplexer can be obtained in the form of a block diagram.

#boiler troubles, Ask question #Minimum 300 words accepted#

Ask question #Minimum 300 words accepted#

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd