#DSP ., Electrical Engineering

Assignment Help:
#The requirement is as follows-
There is a signal which is in the range of 0 to 5Hz. This signal frequency composition is to determined. The resolution of the determination is 1Hz. This means that the signal after being resolved should be represented by a set of frequency and amplitudes ;eg:
Frequency Amplitude
1HZ v
2Hz w
3Hz x
4Hz y
5Hz z
This is to be done with paper- pencil using FFT. The samples for the duration which could be 1.0 sec and sampling rate of twice the highest component expected(2*5) 10 s/sec. the no. of samples would be 10. the work out for the resolution should be done clearly step by step. This exercise would lead to a computer code being written using C/C++question..

Related Discussions:- #DSP .

State the significance of lock signal in 8086, State the significance of LO...

State the significance of LOCK signal in 8086? If 8086 is working at maximum mode, there are multiprocessors are there. If the system bus is given to a processor then the LOCK

Radio communication engineering, how electromagnetic wave transmitted from ...

how electromagnetic wave transmitted from the ground are bent back towards the earth when they enter a layer of ionosphere?

Series-carry synchronous counter with t flip-flops, Q. Consider a series-ca...

Q. Consider a series-carry synchronous counter with T flip-flops shown in Figure in which the AND gates carry forward the transitions of the flip-flops, thereby improving the speed

Commercial losses in electrical systems, Commercial Losses in Electrical Sy...

Commercial Losses in Electrical Systems Commercial losses are caused by pilferage, theft, defective meters, and errors in meter reading and in estimating un-metered supply of

What is txd, What is TXD? TXD- Transmitter Data Output This output p...

What is TXD? TXD- Transmitter Data Output This output pin carries serial stream of the transmitted data bits by with other information like start bit, stop bits and priority

Determine the angular frequency, Q. For given asymptotic Bode plots. (a)...

Q. For given asymptotic Bode plots. (a) Find ¯H 1 , ¯H 2 , and ¯H 3 at ω = 5 rad/s. (b) At what angular frequency ω is the magnitude of ¯H 4 (jω) one-half of the magnitude o

Determine the output voltage increment, (a) Design a 6-bit R-2 R ladder D/A...

(a) Design a 6-bit R-2 R ladder D/A converter. (b) For V ref = 10 V, find the maximum output voltage. (c) Determine the output voltage increment. (d) If the output voltag

Fermi dirac level, Fermi Dirac level: Sol. The Fermi level is simply...

Fermi Dirac level: Sol. The Fermi level is simply a reference energy level. It is the energy level at which the probability of finding an electron n energy unit above it in

Explain resistance-capacitance coupling, Q. Explain Resistance-capacitance ...

Q. Explain Resistance-capacitance coupling? It is the most commonly used coupling in discrete device amplifier as it is least expensive and has satisfactory frequency response.

Equivalent resistor reductions for the circuit, Q. Determine the voltages V...

Q. Determine the voltages V x using voltage division and equivalent resistor reductions for the circuits shown in Figure.

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd