Which metal has material with lowest resistivity, Electrical Engineering

Assignment Help:

The material with lowest resistivity is

(A) Constantan.        

(B) Silver.

(C) manganin.           

(D) nichrome.

Ans:

The material with lowest resistivity is silver.


Related Discussions:- Which metal has material with lowest resistivity

Characteristics of magnetic field / flux lines, Characteristics of magnetic...

Characteristics of magnetic field / flux lines: i.  Forming a closing loop ii. Did not crossed against each other iii. Has a certain direction iv. Repel among one anot

FLOW CHART TO RUN MOTOR, IFYOU AVE TWO DC MOTOR,RELAY,TWO BATTERYAND MICROC...

IFYOU AVE TWO DC MOTOR,RELAY,TWO BATTERYAND MICROCONTROLLER FLOW CHART TO RUN MOTOR AND CONTROL TWO BATTERIES

Find the current in circuit, Q. (a) Determine the voltage at A in Figure...

Q. (a) Determine the voltage at A in Figure . (b) With V i = 10 V, R 1 = 10 k, R 2 = 1000 , and A = 100, find the current i .

What is own-exchange routing, Q. What is Own-exchange routing? Distribu...

Q. What is Own-exchange routing? Distributed routing or own-exchange routing enables alternative routes to be chosen at intermediate nodes. Hence the strategy is capable of res

Find the new synchronous speed, Q. A wye-connected, three-phase, 50-Hz, six...

Q. A wye-connected, three-phase, 50-Hz, six-pole synchronous alternator develops a voltage of 1000 V rms between the lines when the rotor dc field current is 3A. If this alternator

Sources of power dissipation in cmos logic, Describe the three main sources...

Describe the three main sources of power dissipation in CMOS logic. Hence calculate the power dissipated in a CMOS ASIC of 40,000 gates operating at a frequency of 133MHz with a s

Calculate the iron loss, Q. The efficiency of a 400-kVA, single-phase, 60-H...

Q. The efficiency of a 400-kVA, single-phase, 60-Hz transformer is 98.77% when delivering full-load current at 0.8 power factor, and 99.13%with half rated current at unity power fa

Phenomenon - fet operation, Phenomenon - Fet operation: For either imp...

Phenomenon - Fet operation: For either improvement- or depletion-mode devices, at drain-to-source voltages very much less than gate-to-source voltages, changing the gate volta

Semiconductors, Semiconductors Conductivity in among those of metal...

Semiconductors Conductivity in among those of metals and insulators. Conductivity can be changed over orders of magnitude through changes in temperature, optical excitat

Estimate the required bandwidth using Carson''s rule, A 10-kHz tone is used...

A 10-kHz tone is used to frequency modulate a carrier; the peak deviation is 75 kHz. Use Carson''s rule to estimate the bandwidth.

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd