Which interrupt has the highest priority, Electrical Engineering

Assignment Help:

TRAP has the maximum priority

There are 2 types of interrupts external and internal. NMI has highest priority between all external interrupts,TRAP has highest priority between all internal interrupts.

 

 


Related Discussions:- Which interrupt has the highest priority

Case 1 b>a - program description , Case 1 (B>A) Suppose XX = 01H ( s...

Case 1 (B>A) Suppose XX = 01H ( stored in a) and YY = 03H (stored  in B).then carry flag  will set by  CMP  instruction since B>A  in this case JNC  will not  transfer the e

Find the total per-phase inductance, A 300 km, 3-phase, 50Hz transmission l...

A 300 km, 3-phase, 50Hz transmission line has spacing as shown in Figure. Each phase of the line consists of a bundle of three conductors. (a) Find the total per-phase inductanc

Power electronics, A step-down transformer has primary turns Np = 100; seco...

A step-down transformer has primary turns Np = 100; secondary turns Ns = 10; primary winding resistanceRp = 100 ?; secondary winding resistance Rs = 2 ?. Assume that there is no l

Illustrate working of direct-coupled amplifiers, Q. Illustrate working of D...

Q. Illustrate working of Direct-coupled Amplifiers? Direct-coupled Amplifiers : The following figure shows a direct-coupled amplifier consisting of two stages. A dc voltage i

Explain the meaning of ring counters, Explain the meaning of Ring Counters?...

Explain the meaning of Ring Counters? A ring counter is fundamentally a circulating shift register in which the output of the most significant stage is fed back to the input of

Voltage, the relation between power

the relation between power

Explain loads - generation and absorption of reactive power, Explain Loads ...

Explain Loads - Generation and Absorption of Reactive Power A load at 0.95 power factor implies a reactive power demand of 0.33 kVAr per kW of power. When planning a network, i

The filter capacitor , It is needed to use a half-wave rectifier for a dc p...

It is needed to use a half-wave rectifier for a dc power supply that gives an average dc output voltage of 15 V and a maximum ±1V ripple is permitted. The rectifier feeds a load of

Determine the voltages vx using voltage division, Q. Determine the voltages...

Q. Determine the voltages Vx using voltage division and equivalent resistor reductions for the circuits shown in Figure.

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd