What is tie-line rule, Chemical Engineering

Assignment Help:

What is tie-line rule?

The tie-line rule is applied to verify the compositions of two co-existing phases in a binary phase diagram. The tie line is a horizontal line drawn at the temperature of interest within the two phase region. The tie line rule is not concerned with phases. It can be applied only in the two stage region. The overall compositions of two co-existing phases remain similar on the tie-line. There is change only in their relative amounts which is explained by the lever rule.

 


Related Discussions:- What is tie-line rule

Moment, the frame in figure consisted of members AB and BCD connected by pi...

the frame in figure consisted of members AB and BCD connected by pin at B, and member AB is a quarter circle of radius 75mm. the whole frame is supported by pins at A and C. for th

Find the entropy change of the system, A system with constant heat capacity...

A system with constant heat capacity CP and initial temperature T1 is heated by contacting a reservoir at Tf . Find the entropy change of the system, reservoir, and system plus res

Objectives-design and organisation of laboratory store, Objectives Afte...

Objectives After performing this exercise you should be able to: 1. describe the design and organisation of a lab store, 2. suggest modifications in the store design,

What are the different types of point defects, What are the different types...

What are the different types of point defects (i) Vacancies (ii) Interstitialcies Compositional defect (iii) Substitutional impurity (iv) Electronic defects

Hardness of water, Formulas for determining temporary and permanent hardnes...

Formulas for determining temporary and permanent hardness

Liquid holdup, can anyone tell me something about this term

can anyone tell me something about this term

Determine the maximum gain of the system, Consider a heat-exchanger control...

Consider a heat-exchanger control loop with no dead time.  It is controlled by a PD controller.  The rate time is 0.25 min.  A real PD controller is used with filtering where a = 0

Types of polarization processes, The various types of polarization processe...

The various types of polarization processes are: a)  Electronic polarization b)  Ionic Polarization c)  Orientation Polarization, and d)  Space charge Polarization

Dynamics, kenematics of rigid body in rotation

kenematics of rigid body in rotation

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd