What is meant by polling, Electrical Engineering

Assignment Help:

What is meant by polling?

Polling or device polling is a process which recognizes the device that has interrupted the microprocessor.

 


Related Discussions:- What is meant by polling

Control systems, Hi, What is the time response for a closed loop transfer f...

Hi, What is the time response for a closed loop transfer function:H(s) = 10/(s^2 +s +1) to delta function input?

Define diffusion length, Define diffusion length: Sol. Diffusion len...

Define diffusion length: Sol. Diffusion length is defined as the distance, travelled by free carriers before recombining. It may also be defined as the average distance cove

Determine angle between incident ray and reflected ray, Assume a ray of lig...

Assume a ray of light is incident on a smooth reflecting surface at an angle of incidence of 15 degrees to the normal. What is the angle between the incident ray and the reflected

Clapp oscillator, having looked at the circuit, i first wanted to start my ...

having looked at the circuit, i first wanted to start my frequency from 0 and plot for 10000 to 20000. so in matlab i used f = 0:10000:20000; but the equation for frequency is f= 1

Live human detection robot, which simulation software is better for this p...

which simulation software is better for this project, and how can i simulate it?

Find the transmitters unmodulated carrier power, At the transmitter in a st...

At the transmitter in a standard AM system, P f = 50 W. In the receiver (S 0 /N 0 ) AM = 250 when (S i /N i ) AM = 3000. Find the transmitter's unmodulated carrier power and t

Mov - move instruction, MOV ( Move ) Instruction It copies  the content...

MOV ( Move ) Instruction It copies  the contents of the sources register into destination register. The general format is . This  instruction  is used  to copy 8 bit  from s

Why two rectifier is used in smps, Its not essential that a power plant use...

Its not essential that a power plant uses only two rectifiers, it depends on the load there at the site and the capacity of the rectifier or SMPS. Assume the load at the site is 12

Selection of proper fuse in electricity and gas hazards, Selection of Prope...

Selection of Proper Fuse : Fuse is a safety device or a wire of metal in a cut-out which may be fused by an excessive current. The current drawn by an appliance is restricted by t

Calculate the current flow using thevenin''s theorem, Calculate the curren...

Calculate the current flow in 30Ω resistor for the circuit in figure using Thevenin's Theorem.

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd