What is meant by interrupt, Electrical Engineering

Assignment Help:

What is meant by interrupt?

Interrupt is an external signal that causes a microprocessor to jump to a particular subroutine.

 


Related Discussions:- What is meant by interrupt

What is digital system components, Q. What is Digital system components? ...

Q. What is Digital system components? The reason that digital systems are so inexpensive and yet so powerful is that they consist of very  large numbers of just a few building

Describe about boltzmann constant, Q. Describe about Boltzmann constant? ...

Q. Describe about Boltzmann constant? The constant η in Figure (b) stands for the noise power spectral density, expressed in terms of power per unit frequency (W/Hz). Statistic

Analysis of aspects of design for excellence, We commissioned a 'bad practi...

We commissioned a 'bad practice exemplar' by asking Plexus to modify a good design (provided by Valor) to demonstrate the most likely kinds of faults in each of the areas Design fo

Digital control system, block diagram of digital control system and explain...

block diagram of digital control system and explain each block

List the addressing modes supported by 8051, List the addressing modes supp...

List the addressing modes supported by 8051. 1. Register addressing  2. Direct  addressing 3. Register indirect addressing 4. Immediate addressing 5.Register addres

Effect of feedback on dynamic response and bandwidth, Q. Effect of feedback...

Q. Effect of feedback on dynamic response and bandwidth? Let us consider the block-diagram representation of the open-loop system shown in Figure 16.2.5(a), whose direct transf

Static characteristics of the npn silicon bjt, Consider the common-emitter ...

Consider the common-emitter BJT circuit shown in Figure (a). The static characteristics of the npn silicon BJT are given in Figure (b) along with the load line. Calculate iB for v

Show the dot convention, Q. For the coupled coils shown in Figure, a dot ha...

Q. For the coupled coils shown in Figure, a dot has been arbitrarily assigned to a terminal as indicated. Following the dot convention presented in the text, place the other dot in

What would the cutoff frequency, Q. The cutoff frequency of a dominant mode...

Q. The cutoff frequency of a dominant mode in an air-?lled rectangular waveguide is 3 GHz. What would the cutoff frequency be if the same wave - guide were ?lled with a lossless di

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd