What is a co-processor, Electrical Engineering

Assignment Help:

What is a co-processor?

8087 NDP (numerical data processor) is also termed as math co-processor that is used in parallel with the major processor for number crunching applications that would otherwise require complex programming. This is also faster than 8086/8088 processor during performing mathematical computation. This has its own specialized instruction sets to handle mathematical programs.


Related Discussions:- What is a co-processor

TTL NAND gate, Q. Explain working of TTL NAND gate? The TTL logic famil...

Q. Explain working of TTL NAND gate? The TTL logic family uses only transistors instead of a combination of transistors and diodes. TTL has the same high and low ranges as DTL.

Dsp, A pure sine wave with a frequency of 100Hz is sampled at 150Hz. At whi...

A pure sine wave with a frequency of 100Hz is sampled at 150Hz. At which one of the following frequencies would you expect an alias?

Sinusoidal analysis by using mesh equations and matlab, This example is con...

This example is concerned with steady-state sinusoidal analysis by using mesh equations and MATLAB. Let us consider the circuit shown in Figure and find the input impedance at the

Subtract registers and borrow from accumulator, Subtract Registers and Borr...

Subtract Registers and Borrow from Accumulator The  contents of the  register  and borrow  flag  are subtracted from   the contents of the accumulator and the  result is  store

Why do we use xra a instruction, Why do we use XRA A instruction The XR...

Why do we use XRA A instruction The XRA A instruction is used to clear the contents of the Accumulator and keep the value 00H.

Electric machinery fundamentals, Ask qu1. If the resistor Radj is adjusted ...

Ask qu1. If the resistor Radj is adjusted to 175O what is the rotational speed of the motor at no-load conditions? 2. Assuming no armature reaction, what is the speed of the motor

Sketch the individual phase flux contributions, Q. Consider the balanced th...

Q. Consider the balanced three-phase alternating currents, shown in Figure, to be flowing in phases a, b, and c, respectively, of the two pole stator structure shown in Figure with

Use mesh analysis and nodal analysis to determine voltage, Q. Use (a) mesh ...

Q. Use (a) mesh analysis and (b) nodal analysis to determine the voltage ¯V at the terminals A-B of Figure.

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd