What do you understand by binders, Mechanical Engineering

Assignment Help:

Q. What do you understand by Binders?

Binders used in a foundry are : Inorganic and organic binders. Organic binders used for core making and will be discussed later.

Clay binders are the main inorganic binders. Clays are formed by weathering and decomposition of rocks. the common type of clay used in the moulding sand are fireclay, kaolinite, illite, and bentonite clays are most popular, because they have high thermo chemical stability.


Related Discussions:- What do you understand by binders

Relations Among Load, 5. Calculate and draw the Shear force and Bending mom...

5. Calculate and draw the Shear force and Bending moment diagrams for the loaded beam and determine the maximum moment M and its location x from left end

Resolution of a force - mechanics, Resolution of a force: Sol.: When...

Resolution of a force: Sol.: When a force is resolved into two parts along the two mutually perpendicular directions, without changing the effects of it on the body, the par

Equipment for resistance welding-measurements, EQUIPMENT FOR RESISTANCE WEL...

EQUIPMENT FOR RESISTANCE WELDING-Measurements Measurement of the parameters are important while fixing the parameters or testing a machine. Resistance welding instrumentation s

Dryness fraction of steam - thermodynamics, Drynes s Fraction of Steam: ...

Drynes s Fraction of Steam: Dryness fraction of steam is factor which used to specify the quality of steam. It can be defined as the ratio of weight of dry steam W d s pr

Determine the stresses in each rod, A rigid bar ABCD is hinged at A and sup...

A rigid bar ABCD is hinged at A and supported by a bronze rod, 2m long, and a steel rod 1m long as shown in figure A load of 80 KN is applied at end B. Determine the stresses in ea

What is the pressure difference between the stations , (Bernoulli equation ...

(Bernoulli equation along a streamline) Water flows from station (1) to (2) around an expanding corner pipe, 3m high. The speed along the center streamline is 10 m/s at (1) and 5

Determine standard for the specific standard technical areas, Standard for ...

Standard for the specific standard technical areas These norms are based on previously described models. Typical categories of these norms are: (a)  drafting, which describe

Oil seal found still leaking-stator plate oil seal complaint, After trial i...

After trial if oil seal found still leaking: Dismantle engine and check crank shaft for run out which should not be more than 0.10 mm.

Complete outer clutch lugs for deep cuts, Complete outer clutch lugs for de...

Complete outer clutch lugs for deep cuts: Visually check for any deep cuts formed on the outer complete clutch lugs.

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd