Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
What are the Technical Limitations of screw conveyer
Technical Limitations:
? Turning limitation of this mechanism
Actually the Maximum Turning of U-joint is 18° to 22° but, we required angular turning is 60° to 90° because of proper moment in desired space is required for angular turning of extra auger in main auger shafts through a U-joint in this mechanisms.
? Additional cost Due to extra hydraulic cylinder.
We require the four cylinders are used in this mechanisms for extension of auger in main auger shaft and that why the additional cost is increased.
Transportation Problem.
Due to transportation of paver machine from one place to another by the heavy vehicle such as trucks. This mechanism is overhanging to the chassis of machine. So this reason the transportation problem is occurred.
? Mounting problem.
? Motion Restriction.
When the hydraulic cylinder is provide to that mechanism for operation of paving with extension but it is the motion is restricted in only one plane not other planes then due to dynamic balancing is not proper and not withstand the load during the operation and motion is restricted in other plane the increase the complexity and also increase the cost
assignment on the topics of preservation of safety & accident
Find velocity of the vehicle: A car having mass 400kg is moving with velocity of 20m/sec. A force of 200N that acts on it for 2 mins. Find velocity of the vehicle: (1) W
Find out ratio of strain-energy: A circular rod of diameter d and length l is fixed at one end and a torque T applied at the other. Now, if any close coiled helical spring is
(a) Show that the force exerted by a jet of water on an inclined fixed plate in the dissection of jet is given by fx = .a.v 2 . sin 2 θ. Where a is area of jet, v is velocity of j
Q. Find out M.I. of T section as shown in figure given below about X - X and Y - Y axis through center of gravity of the section. Figure Sol.:
Composite materials consist of two or more distinct components. Generally we refer to a matrix and a reinforcement . The reinforcement can be in the form of fibres (continuous
What is In-Line IC Engines?
DESIGN FACT DATA: ?A) Torque capacity for traction motor of screw conveyor-1660 N-m. ? B) RPM of Traction motor-115 rpm. ? C) Pressure require for operating the telescopi
Gradual Engagement : The clutch should positively take the drive gradually without the occurrence of sudden jerks.
Working of stream engine: The high pressure steam from boiler is supplied to the steam chest. The high pressure steam enters cylinder through inlet port and exerts pressure on
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +91-977-207-8620
Phone: +91-977-207-8620
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd