Poisionsratio,

Magnesium and its alloys, Magnesium And Its Alloys Magnesium is a light...

Magnesium And Its Alloys Magnesium is a light metal along with density of 1.74 g/cm 3 . Magnesium is more costly than aluminium as density 2.74 g/cm 3 along with which it comp

Voltage -fundamentals of electricity , Voltage: The voltage is the potent...

Voltage: The voltage is the potential difference between two points. The current flows from higher potential to lower potential. Voltage is measured in volts (V). V = IR

Classification of cast iron, Classification of Cast Iron: CI having C...

Classification of Cast Iron: CI having C in form of cementite is named as white cast iron. Microstructure of that CI consists of pearlite, cementite and ledeburite. Whether C

Determine the wire diameter of the inner spring, Determine the wire diamete...

Determine the wire diameter of the inner spring: In a compound helical spring, the inner spring is arranged in and concentric with the outer one, but is 10 mm shorter. The out

Mechanics of material, thin and thick cylider theory

thin and thick cylider theory

Determine the crippling load and safe load, A hollow mild steel tube 6 m lo...

A hollow mild steel tube 6 m long 4 cm internal diameter and 6 mm thick is used as a strut with both ends hinged. Determine the crippling load and safe load taking factor of safety

Platforms - planning of railway stations, Platforms: Platforms are pl...

Platforms: Platforms are places where trains stop and passengers entrain and detrain. For BG operations, the length of the platform should be about 30 m. Figure gives the

Compute the deflection and maximum bending stress, For the beam shown in Fi...

For the beam shown in Figure compute the deflection at the element nodes. The modulus of elasticity is psi and the cross section is as shown in the figure. Also compute the maximum

Determine the equivalent evaporation, Illustrate how the efficiency of Rank...

Illustrate how the efficiency of Rankine Cycle can be improved by the use of Regenerative and Reheat heating. (b) During a test on boiler trial the following data were obtained