Takt time for sand blasting, Mechanical Engineering

Assignment Help:

Takt Time for sand blasting:

            Tatk time is crucial in manufacturing process. It determines the speed of production to produce a product. Time is money toward production, the lesser the time taken to produce a part the lower the cost it is. The less time consume per day to manufacture a product helped to increase productivity per day. For this sand blasting is very important to determine the takt time of blasting. We also need to consider the quality of blasting did meet our expectation. It is crucial to get the suitable duration for de-burrs the blade without failure.

Experiment data:

Second taken

Air pressure

2.0 bar

3.0 bar

5

x

x

10

x

x

15

x

x

20

x

25

Table: Test result on takt time

            As experiment result shown that applying vertical sand blasting method with 3.0 bars air pressure mixture are required to blast estimated 20 second to meet our quality requirement. As previous data we apply around 30 second for each experiment. Now our blades are free of burrs after sand blasting process. We need to process the blade to cutting test.


Related Discussions:- Takt time for sand blasting

Carnot cycle, matlab programme for carnot cycle

matlab programme for carnot cycle

Determine the forces in members in roof truss, Determine the Forces in Memb...

Determine the Forces in Members in Roof Truss Determine the forces in members EF, EL, FL, and LK in the roof truss shown below and state whether the members are in tension or

Aggregate production planning, Aggregate Production Planning: This uni...

Aggregate Production Planning: This unit provides the definition and physical significance of aggregate production planning. Further, this is illustrated that how the internal

Pressure, relation between fluid pressure and velocity

relation between fluid pressure and velocity

Find minimum time for a vehicle to go from 0 to 60 mph, For a few of the fo...

For a few of the following problems the constant acceleration is due to gravity and will be notated as a = g = 32 ft/sec 2 . 'g' perhaps positive or negative depending on the conte

Order sequences and order release, Order Sequences and Order Release Fo...

Order Sequences and Order Release For this system, sequences of orders for particular parts (batch size 1) are produced in the following way: for each machine, here is, for eac

Elastomers, define elastomer.explain in details?

define elastomer.explain in details?

The ordinate dimension command-autocad, The Ordinate Dimension Command ...

The Ordinate Dimension Command We can use The Ordinate command to annotate co-ordinate points with X or Y values. This might be useful for setting-out on site plans.

Evaluate the stresses in the rod, A steel tube of 30 mm external diameter a...

A steel tube of 30 mm external diameter and 20mm internal diameter encloses a copper rod of 15mm diameter to which it is rigidly joined at each end. If at a temperature of 10 o C,

Design requirements, A steel member supported by a tie bar has a load of 15...

A steel member supported by a tie bar has a load of 15 000 lbs on it. If the force on the steel member of 1.2 in 2 cross section is 14,180 lbs and the force on the tie bar of diam

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd