What are the need of a surface condensing, Mechanical Engineering

Assignment Help:

(a) What are the need of a surface condensing ? Write disadvantages and advantages of Jet condenser and surface condenser.

(b) A surface condenser is designed to handle 10000 Kg of steam/hr. The steam enters at 0.08 bar and 0.9 dny and leaves the condenser
at a corresponding saturation temperature. The pressure is constant throughout the condenser. Determine the cooling water flow rate/hr,
if cooling water temperature rise is limited to 10^oC

Related Discussions:- What are the need of a surface condensing

Molding sand , which are the different types of molding sands?explain each

which are the different types of molding sands?explain each

Carburettor cleaning of motorcycle, Carburettor Cleaning: Carburettor nee...

Carburettor Cleaning: Carburettor needs to be cleaned otherwise the jets may get clogged which may supply an inadequate amount of air fuel mixture. Inadequate amount of air fuel

Stress strain curves, Stress Strai n Curves (Tension): When a bar or ...

Stress Strai n Curves (Tension): When a bar or specimen is subjected to a gradually increasing axial tensile load, the strains and stresses can be found out for number of loa

Root sheet of hammer production.., how we can do root sheet of hammer?

how we can do root sheet of hammer?

Strength of material and engineering mechanics, Di fferentiate between str...

Di fferentiate between strength of material and engineering mechanics Sol.: Three primary areas of mechanics of solids are statics, dynamics and the strength of materials.

Throttle free play adjustment of motor cycle, Throttle Free Play Adjustmen:...

Throttle Free Play Adjustmen: A smooth operation of the throttle ensures proper acceleration of the vehicle according to the requirement of the rider. If the throttle cable is kin

Low lube oil pressure security in API612 , What type of low lube oil securi...

What type of low lube oil security recommended for API612 steam turbines.(Electronic/Mechanical). Please give refrences

V pulley design, What will be the criteria to be looked into get the pulley...

What will be the criteria to be looked into get the pulley rpm increase

Question.., Two concentric perforared plates are seperated by a 200mm laund...

Two concentric perforared plates are seperated by a 200mm launder and form the flow exit for a clarifier (figure 1). The inlet water flow of 1200 mcubed/hour into the clarifier is

Layout of vessels in plant design, Q. Layout of vessels in plant design? ...

Q. Layout of vessels in plant design? Layout of vessels needs to allow sufficient spacing for instruments, piping, operations, maintenance and firefighting access. Vessels o

Write Your Message!

Name

Email id

Message

Verfication Code

User Account

All Pages