Wet h2s corrosion, Mechanical Engineering

Assignment Help:

There is risk of wet H2S corrosion in all emulsion and gas lines from the Inlet Separator up to and including the Treater. Full compliance to NACE is highly recommended to control SSC, SOHIC, and CSCC. All vessels in the sour service shall be supplied in clean steel, vacuum degassed, normalized, fully killed and shape control condition to control HIC. The later requirement (shape control) shall be specified as mandatory requirement for severe sour condition when Sour service.


Related Discussions:- Wet h2s corrosion

Material Handling, Identify the basic activities involved in the use of int...

Identify the basic activities involved in the use of intermittent operation in handling machines in material handling?

Thermophyics, The steam that leaves the super-heater is expanded from 130ba...

The steam that leaves the super-heater is expanded from 130bar at 535°C to 25.2bar at 310°C in a high pressure turbine. The steam from the exit of the HP turbine is reheated to 535

Motorcycle servicing , In motorcycle servicing we studied about various ser...

In motorcycle servicing we studied about various service tips for motorcycle servicing. These steps will ensure proper servicing of motorcycle and as a result customers will trust

Shut-off valves on major zone, Q. Shut-off valves on major zone? Are shu...

Q. Shut-off valves on major zone? Are shut-off valves on major zone branches and on the bottom and top of riser? Are balancing valves on return branches? Are control valves on

Find out the effort required to run this machine, Find out the effort requi...

Find out the effort required to run this machine: The efficiency of a machine is 75% while an effort of 20 N is required to lift a load of 160 N. Compute the velocity ratio an

AOC, The objective of the project is to protect damage of the DC motors. If...

The objective of the project is to protect damage of the DC motors. If the motor is not working it will be shown with red light, if working normally then green and if working at a

Determine the reactions at the points of supports, Two identical rollers, e...

Two identical rollers, each of weight W= 1000N are placed by an inclined plane and a vertical wall as shown below. Determine the reactions at the points of supports A, B, and C. Su

Explain the single cast component auger, Explain the Single Cast Component ...

Explain the Single Cast Component Auger Material for Single Cast Component Auger: Either Ni-Cr or Cast iron Length of components: 1250 mm. Outer Diameter of Auger compone

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd