V-block and clamp - angle projection drawing, Mechanical Engineering

Assignment Help:

A V-block clamp consists of 3 components, a V-block, yoke and clamping screw.  Using a rule, measure the sketches below and produce a 3rd angle projection drawing for each component.  All drawings must be fully dimensioned, with the relevant projection symbol, on a completed drawing sheet. 

Indicate any important tolerances for each component. A completed 2 view assembly drawing is also required showing each component in its relevant position, with information bubbles relating to a parts list on the drawing.  The parts list must indicate, part name, page number, material, and number off, for each component. Finally on a separate sheet produce a free hand sketch of the completed assembly.


Related Discussions:- V-block and clamp - angle projection drawing

What are the objectives of bearing capacity, What are the objectives of bea...

What are the objectives of bearing capacity? The objectives of bearing capacity: a. identify the possible modes of failure that a shallow foundation can undergo, b. under

Calculate the compression ratio - maximum pressure of engine, (a) Derive an...

(a) Derive an expression for the otto cycle to determine the Mean Effective Pressure and efficiency. (b)The two engines are to perform on diesel and otto cycle with the followin

Project, give some best names

give some best names

Two wheeler, how to adjust the motorcycle clutch play

how to adjust the motorcycle clutch play

Carburettor cleaning of motorcycle, Carburettor Cleaning:  Carburettor nee...

Carburettor Cleaning:  Carburettor needs to be cleaned otherwise the jets may get clogged which may supply an inadequate amount of air fuel mixture. Inadequate amount of air fuel

Maximum shear stress and angle of twist, Maximum shear stress and angle of ...

Maximum shear stress and angle of twist: Torques are applied on the shaft as illustrated in Figure. Discover in which portion of the shaft, maximum shear stress & angle of twi

Identification of pressure welds, Q. Identification of Pressure Welds? ...

Q. Identification of Pressure Welds? Pressure welds shall be identified as follows: a. Generally each weld shall be stamped adjacent to the weld with the welder's identity c

For elevated temperatures, For Elevated Temperatures, Other Materials  ...

For Elevated Temperatures, Other Materials  High temperature creep is a significant phenomenon to be guarded in various machines like gas turbines, missiles, reentry vehicles a

Determine the reactions at beam, Determine the reactions at bea: A can...

Determine the reactions at bea: A cantilever AB, 1.8 m long is fixed at A and carries uniformly distributed load of 20 kN/m over its entire length and a point load of 30 kN at

What do you mean by flares and vents, Q. What do you mean by Flares and Ven...

Q. What do you mean by Flares and Vents? A vent is a potential gas fuel source and a potential liquid fuel source due to carry-over from the vent. This is also true for a flare

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd