Use plain dumb-bell type and center-bulb sort, Civil Engineering

Assignment Help:

Question

While selection of waterstop, shall engineers use plain dumb-bell type , center-bulb sort?


Answer

Plain dumb-bell kind is used for joint site where small movements are anticipated. So, construction joints are desirable sites of this type of waterstop. On other hand, center-bulb type waterstop is appropriate for growth joints or locations anywhere lateral and shear movements happen due to settlement.

 


Related Discussions:- Use plain dumb-bell type and center-bulb sort

#title.roads., metal sizes required and adopted question #Minimum 100 words...

metal sizes required and adopted question #Minimum 100 words accepted#

Dissimilarity b/w air chamber and surge tank, Question What is dissimil...

Question What is dissimilarity between air chamber and surge tank ? Answer Air chambers and surge tanks are usually set up in watermain to ease stress on schem

Diffrence between hudsons and van der meer formula, Q. Diffrence between Hu...

Q. Diffrence between Hudsons and Van der Meer formula? Hudson's formula is usually adopted in preliminary design to attain rough initial estimate of rock size. This formula is

Spalling reinforcement for pre stressing works, Spalling reinforcement for ...

Spalling reinforcement for pre stressing works in anchor blocks Reinforcement of anchor blocks in prestressing works usuallycomprises equilibrium reinforcement, bursting reinfo

Which is stronger solid steel rod or hollow steel pipe, On a per pound basi...

On a per pound basis, steel pipe is stronger in bending and is less likely to buckle in axial compression.

Determine the term- shrinkage of concrete, Determine the term- Shrinkage of...

Determine the term- Shrinkage of Concrete Shrinkage of concrete is primarily due to gradual loss of moisture which results in change in volume. The shrinkage of concrete depend

Axial flow pumps for large flows and low heads, Q. Axial flow pumps for lar...

Q. Axial flow pumps for large flows and low heads? It is well known that axial flow pumps are the most suitable for providing large flows and low heads. Reason behind this is c

How to design marginal embankments, Q. How to design Marginal Embankments? ...

Q. How to design Marginal Embankments? Design aspects of marginal embankments are similar to those of approach banks. The aspects needing special attention are dealt with below

Environmental Question, An activated sludge tank treats 1 MGD from the pri...

An activated sludge tank treats 1 MGD from the primary clarify and has an X of 2200 ppm SS. The water euent is 0.9 MGD. 1.0 MGD of the sludge is recycled back into the tank and has

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd