uphill pulley and release back system, Mechanical Engineering

Assignment Help:
I was wondering if anyone could help me design an aid for my pet rat that has hind leg degeneration. I have a long slope where i can train him to climb on some kind of trolley and was thinking his weight would release a brake and a weight would pull it up the slope. the tricky part (for me anyway) is getting the trolley back to its original position at the bottom of the ramp. The rat can climb down with out any aid on its own. Obviously, both up and down need to move fairly slowly.

Related Discussions:- uphill pulley and release back system

Illustrate the importance of aesthetic consideration, You as design Enginee...

You as design Engineer, Describe how you would decide a suitable factor of safety for the design of a new mechanical elements. Illustrate the importance of aesthetic considerati

Materials used in insulation, Q. Materials used in insulation? All mate...

Q. Materials used in insulation? All materials must be non-corrosive, compatible with other materials and used in accordance with the Manufacturer's recommendations. All mat

First gear position -Shifting of Gears , First Gear Position : When gear M...

First Gear Position : When gear M1 is in mesh with gear C1 then this is first gear drive position. The gear C1 is freely attached to counter shaft, so gear C1 itself cannot rotate

Determine the chemical formulate for refrigerant, (a) Draw P-H and T-S diag...

(a) Draw P-H and T-S diagrams for following cases : (3) (i) Cycle with superheated vapour before compression. (ii) Cycle with sub-cooling or under-cooling of refrigerant.

Relation between stress and strain, Relation between stress and strain: ...

Relation between stress and strain: The relation between stress and strain is generally shown by plotting a stress-strain (σ -e) diagram. Stress can be plotted on ordinate (ve

Insulatlon application information, The Contractor shall perform all work w...

The Contractor shall perform all work with the highest quality workmanship throughout to provide a neat, uniform appearance with no sharp edges exposed. Insulation shall not be

Calculate the machine power factor, A 3-phase, 15-kV, 4-pole, cylindrical r...

A 3-phase, 15-kV, 4-pole, cylindrical rotor synchronous generator is connected to a 50-Hz infinite bus. The synchronous reactance of the machine is X s = 0.6 ohms per phase and th

Explain roughness width and roughness width cut off, Explain Roughness widt...

Explain Roughness width and Roughness width cut off? Roughness width: - Roughness width is the distance parallel to the normal surface between successive peaks or ridges whic

Requirements for vessels with thickness, Q. Requirements for vessels with t...

Q. Requirements for vessels with thickness? The following additional requirements are applicable, as specified,  to Carbon Steel and Low Alloy steel pressure vessels with main

Modulus of elasticity, Explain Young's Modulus or Modulus of elasticity? ...

Explain Young's Modulus or Modulus of elasticity? Sol. : It is ratio between tensile stress and tensile strain or compressive stress and compressive strain. It can be denote

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd