The resistance of an electrical conductor, Electrical Engineering

Assignment Help:

The resistance of an electrical conductor depends on 4 factors, these being:

 

a)  The length of the conductor

 

b)  The cross-sectional area of the conductor

 

c)  The type of material

d)  The temperature of the material

 


Related Discussions:- The resistance of an electrical conductor

Determine the armature current and power factor of the motor, A three-phase...

A three-phase, wye-connected, 2300-V, 60-Hz, round-rotor synchronous motor has a syn- chronous reactance of 2 per phase and negligible armature resistance. (a) If the motor tak

Explain the term full duplex transmission, Explain the term full duplex tra...

Explain the term full duplex transmission. Data can travel in both directions concurrently. There is no require to switch from transmit to receive mode as in half duplex. It's

Weighted-resistor converter, Q. WEIGHTED-RESISTOR CONVERTER? Figure sho...

Q. WEIGHTED-RESISTOR CONVERTER? Figure shows a 4-bit weighted-resistor D/A converter which includes a reference voltage source, a set of four electronically controlled switches

Transfer characteristics , Transfer Characteristics The  transfer char...

Transfer Characteristics The  transfer characteristics of power MOSFET   transfer characteristic shown the variation of ID with V GS    denote the drain current  with shorted

What are flip flop circuits in digital electronics, What are flip flop circ...

What are flip flop circuits in digital electronics? Discuss race around condition in J-K Flip Flop

How dram’s are different from sram’s, How DRAM's are different from SRAM's?...

How DRAM's are different from SRAM's? Why DRAMs are said to use address multiplexing? Ans Dynamic RAM (DRAM) is basically the same as SRAM except that it recollects data f

Determine the advantages of e-nrz over nrz, 1. A modi?ed NRZ code known as ...

1. A modi?ed NRZ code known as enhanced-NRZ (E-NRZ) operates on 7-bit words; invert- ing bits 2,3,6 and 7; and adding one parity bit to each word. The parity bit is chosen to make

Gis technology, GIS technology: GIS could be used to derive diverse in...

GIS technology: GIS could be used to derive diverse information for efficient technical and commercial management of a power distribution utility, e.g., capacity analysis, inv

Dc machines, a 400V 4-pole DC generator takes an armature current of 50A wh...

a 400V 4-pole DC generator takes an armature current of 50A when rotating at 626 rpm. the armature circuit resistance is 0,25ohms. determine the generated emf. DOC

Obtain complete solution for the current for given circuit, For the circuit...

For the circuit of Figure(a), obtain the complete solution for the current i L (t) through the 5-H inductor and the voltage v x (t) across the 6- resistor.

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd