Steps of servicing -washing and drying a motorcycle, Mechanical Engineering

Assignment Help:

Steps of servicing

Bring the motorcycle in the washing bay.
Clean the motorcycle with recommended soap solution and soft sponge.
Wash the motorcycle with a jet of water thoroughly.
After the motorcycle washing is over, the motorcycle should be taken to drying area.
Motorcycle should be dried with pressurized air.
After motorcycle is thoroughly dried it should be brought to the workshop ramp area.
Put the motorcycle on the ramp on the main stand.
Clamp the main stand.
Clamp the front wheel.
Attach the exhaust duct to the muffler.
According to the requirement, the ramp is raised and locked.

Related Discussions:- Steps of servicing -washing and drying a motorcycle

Define the gear hobbing, Define the Gear Hobbing This is the most produ...

Define the Gear Hobbing This is the most productive of all the gear production processes. However, it can only be used for producing spur gears and worn gears. It cannot be use

Generation of steam at constant pressure - thermodynamics, Generation of st...

Generation of steam at constant pressure: Steam is pure substance. Like any other pure substance it can also be converted into any of the three states, that is, solid, liquid

Simple bending or pure bending of beam, Q: What is simple bending or pure...

Q: What is simple bending or pure bending of beam? Sol.: If portion of beam is subjected to the constant bending moment only and

GOVERNORS, Explain Wilson HArtnell Governor

Explain Wilson HArtnell Governor

What do you mean by flares and vents, Q. What do you mean by Flares and Ven...

Q. What do you mean by Flares and Vents? A vent is a potential gas fuel source and a potential liquid fuel source due to carry-over from the vent. This is also true for a flare

Heat loss in acylindrical pipe, Ask question #Minimum 1. Research the topic...

Ask question #Minimum 1. Research the topic of heat loss in a cylindrical pipe. Explain which laws of physics are used to discuss heat loss in a pipe, and briefly explain how the f

Determine the displacement response time, (i) Formulate the equation of mot...

(i) Formulate the equation of motion for the system shown in Figure. List TWO (2) assumptions made in this formulation. (ii) Find the response of this system at t = 3s. The syst

Prototype sand blast method, During the test run of prototype machine we fo...

During the test run of prototype machine we found out a few issue occurred due to blasting room design problem. The blasting room design is too quartet, this design had cause the b

.safety observation subject, working with complete P.P.E

working with complete P.P.E

Thermodynamics-2, eqation of continuty of nozzle

eqation of continuty of nozzle

Write Your Message!

Name

Email id

Message

Verfication Code

User Account

All Pages