Semilog plot and logarithmic axis, Chemical Engineering

Assignment Help:
"A semilog plot of y(logarithmic axis) versus x passes through (1,2) and (2,1)." The given equation is y=4.00exp(-0.693x).I am supposed to end up with a graph, but I''m not sure if I am supposed to plug in the number to the linear solution of the given equation, or just make a standard semilog plot and dump the data on it.

Related Discussions:- Semilog plot and logarithmic axis

What are the different types of point defects, What are the different types...

What are the different types of point defects (i) Vacancies (ii) Interstitialcies Compositional defect (iii) Substitutional impurity (iv) Electronic defects

What is tie-line rule, What is tie-line rule? The tie-line rule is appl...

What is tie-line rule? The tie-line rule is applied to verify the compositions of two co-existing phases in a binary phase diagram. The tie line is a horizontal line drawn at t

Draw the b-h curve for a ferro-magnetic material, Draw the B-H curve for a ...

Draw the B-H curve for a ferro-magnetic material  and identify the retentivity and the coercive field on the curve.    B-H curve for a ferromagnetic material is drawn a

Molar flow rate., 100 mol/hr of methane reacts with steam to produce CO2 in...

100 mol/hr of methane reacts with steam to produce CO2 in a main reaction of the reformer. The amount of steam used is 12.5% excess based on this main reaction. Some of the methane

Entry and exit points features of a laboratory, Entry and exit points Y...

Entry and exit points You should see them from the point of view of access, convenience and safety. 1. Observations 2. Comments and Suggestions

Bernoulli equations, air flows through apipe at arte of 200L/S. The pipe of...

air flows through apipe at arte of 200L/S. The pipe of two sections of diameters 20cm and 10cm with asmoth reducing section the pressure are difference between the two pipe sectio

Hardness of water, Formulas for determining temporary and permanent hardnes...

Formulas for determining temporary and permanent hardness

Introduction to classifying and handling of hazardous , INTRODUCTION : You...

INTRODUCTION : You have studied about chemical hazards in Unit 13 of Block-3 and would have learnt that many chemicals are hazardous. A good practice is to exercise caution in han

Shear stress, What is the aim of shear stress distribution?

What is the aim of shear stress distribution?

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd