Scanning electron microscope, Mechanical Engineering

Assignment Help:

1- Explain the rationale of using a small WD to improve resolution.

2- In a tungsten SEM , Why does a high accelerating voltage provide the potential for higher resolution?  Why is this counterintuitive?

3- Comment on the desired coating thickness for an insulating sample where maximum resolution is required. What material/s do you suggest for coating and why?


Related Discussions:- Scanning electron microscope

Molecular structure, Molecular Structure The polymers have three disti...

Molecular Structure The polymers have three distinct arrangements of molecular chain, hence resulting in three structures. In amorphous structure the molecular chain are ar

Steam systems - air-conditioning guidelines, Ensure all low points on steam...

Ensure all low points on steam mains and equipment have drip trap assembly. High pressure condensate to be taken to flash tanks, provide detail of flash tank. Use minimum 24" (610

Assignemnt , A heating section consists of a 10 in diameter duct which hous...

A heating section consists of a 10 in diameter duct which houses a 8 kW electric resistance heater. Air enters the heating section at 14.7 psia 40oF, and 35 percent relative humidi

Determine the buckling load, (a) Evaluate the buckling load of column with ...

(a) Evaluate the buckling load of column with one end fixed other free of 8m length by using Euler's formula. Given : I min = 1390m 4 E = 2 X 10 5 N/mm 2 (b) Derive a

Carnot cycle, matlab programme for carnot cycle

matlab programme for carnot cycle

Explain in detail about the pile foundations, Explain in detail about the P...

Explain in detail about the Pile Foundations Where the support given by top soil is not sufficient and the load has to be carried deep down for purposes of stability and contro

Determine the service and backwash rates, Service duty point: 3 m3/h Backw...

Service duty point: 3 m3/h Backwash duty point: 9 m3/h Part (a) What is the speed of the pump to achieve the service and backwash flow rates ? Part (b) What would be the best

Maximum stress failure criterion, a) Determine the value of σ 0 to cause f...

a) Determine the value of σ 0 to cause failure when θ=30°, according to the maximum stress failure criterion.  Consider both σ 0 > 0 and σ 0 e.g. "failure in longitudinal tens

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd