Resource management for project, Mechanical Engineering

Assignment Help:

Q. Resource Management for project?

An important factor in overall project success is the provision of suitable and adequate resources. The initial estimate of engineering manhours and schedule provide the basis for the planned resource allocation (manpower) to a project.

Just as important as the original manpower plan is the subsequent monitoring of resources. Project changes in scope and schedule along with an ongoing evaluation of progress measurement can lead to deviation from the original plan and the need to re-assess manpower allocated to the project.

In consideration of the above, the Lead Mechanical Engineer will undertake periodic reviews (weekly, bi-weekly, etc., as identified in the Project Execution Plan) of engineering performance (manhours planned/ spent, progress) in order to determine if any corrective actions are required.


Related Discussions:- Resource management for project

What is stormwater treatment, Q. What is Stormwater Treatment? Normally...

Q. What is Stormwater Treatment? Normally, stormwater run-off from process areas needs to be collected and treated before being discharged to land or water. Often, large aerobi

Resolve a force system in to single force, Resolve a force system in to sin...

Resolve a force system in to single force: Resolve a force system in to single force and a couple systems. Also explain the Equivalent force couple system. Or 'A

Determine the response of the system, A force F(t) is suddenly applied to a...

A force F(t) is suddenly applied to a mass m which is supported by a spring with a constant stiffness ‘K'. After a short period of time T, the force is suddenly removed. In the mea

Dislocation, Diff. B/w edge and screw dislocation

Diff. B/w edge and screw dislocation

#flow rate in turbochargers, What is the amount of air is supplied to engin...

What is the amount of air is supplied to engine via turbochargers and how their sizes vary from engine to engine ?

Evaluate the point of contraflexure, Evaluate the point of contraflexure: ...

Evaluate the point of contraflexure: An overhanging beam of 15 m span is carrying a consistently distributed load of 1 kN/m over the length of 10 m at a distance 5 m from the

Find distance through which the body will penetrates, Find distance through...

Find distance through which the body will penetrates: A body having mass 25kg falls on the ground from height of 19.6m. The body penetrates into ground. Find distance through

Compressive strain, Compressiv e Strain: When the compressive load ac...

Compressiv e Strain: When the compressive load acts on body then there will be an increase in cross sectional area and decrease in length of body. The ratio of reduction in l

Show the water treatment unit, The de-oiled water from De-Oiling Unit enter...

The de-oiled water from De-Oiling Unit enters the HLS vessel for softening. The primary function of HLS is to remove the Ca and Mg hardness and bring the total hardness to less tha

Residual stress and deformation in aluminum, deformation and stress in alum...

deformation and stress in aluminum 6061 after extrusion

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd