power system engineering, Electrical Engineering

Assignment Help:
A three-phase transposed line is composed of one ACSR conductor per phase with flat horizontal spacing of 11 meters as shown in Figure (a). The conductors have a diameter of 3.625 cm. The line is to be replaced by a three-conductor bundle of ACSR. Each conductor of bundle is having the same diameter as the single-conductor line. The new line will also have a flat horizontal configuration, but it is to be operated at a higher voltage and therefore the phase spacing is increased to 14 m as measured from the center of the bundles as shown in Figure (b). The spacing between the conductors in the bundle is 45 cm. Determine
(a) The percentage change in the inductance.
(b) The percentage change in the capacitance.

Related Discussions:- power system engineering

A, A microstrip antenna system operating at 915MHz must be designed using R...

A microstrip antenna system operating at 915MHz must be designed using Rogers RO3010 substrate with the thickness of 0.635mm.

Microprocessor system, A burglar alarm system is controlled by a microproce...

A burglar alarm system is controlled by a microprocessor system. The system has three independent circuit each consisting of 7 passive infra red sensors. The controller can be prog

Solid state devices, what are the significance of solid state devices in el...

what are the significance of solid state devices in electrical engineering

LED should also show the rounded percentage , The LEDs should also show th...

The LEDs should also show the rounded percentage of the full scale output. Since there are 8 LEDs every one represents 12.5%. Though, since we want the rounded percentage the LED o

Digital logic circuits, . In successive-approximation A/D converter, offset...

. In successive-approximation A/D converter, offset voltage equal to 1/2LSB is added to theD/A converter’s output. This is done to

Impact of diversity, Both GSM and DECT use GMSK, but with different Gaussia...

Both GSM and DECT use GMSK, but with different Gaussian filters (BGT = 0.3 in GSM, BGT = 0.5 in DECT). What are the advantages of having a larger bandwidth time product? Why is the

Evaluate hysteresis loss, Q. A magnetic circuit is found to have an ac hyst...

Q. A magnetic circuit is found to have an ac hysteresis loss of 10 W when the peak current is Im = 2 A. Assuming the exponent of Bm to be 1.5, estimate Ph for Im = 0.5A and 8A.

Necessary conditions to maintain sustained oscillation, Q. What are the nec...

Q. What are the necessary conditions to maintain sustained oscillation? The use of positive feedback that results in a feedback amplifier having closed-loop gain |Af| greater t

What can explain failure of relative ppp to hold in reality, Q. What ...

Q. What can explain the failure of relative PPP to hold in reality? Answer: Government procedures of the price level differ from country to country. One cause for thes

Determine the current needed in the coil to produce a flux, Q. Consider the...

Q. Consider the magnetic circuit shown in Figure. Assume the relative permeability of the magnetic material to be 1000 and the cross-sectional area to be the same throughout. Deter

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd