power, Electrical Engineering

Assignment Help:
why do we use commutator?

Related Discussions:- power

Explain index mode and base address mode, Explain index mode and base addre...

Explain index mode and base address mode (with examples) available in microprocessors. Index Mode and Base Address Mode: Address supplied through the instruction is adde

Alternater, if the prime mover input of an alternater connected directly t...

if the prime mover input of an alternater connected directly to an infinite bus in increased,then its?

Determine transformer turns ratio, A flyback converter is to be designed so...

A flyback converter is to be designed so that it operates in continuous "current" (flux) mode with a duty cycle of D = 0.45 when input voltage V s = 48 V, output voltage V o = 30

Explain in detail the operation of 8255 in mode 1, Explain in detail the op...

Explain in detail the operation of 8255 in mode1 taking suitable example. In mode1, Ports A and B are programmed as input or output ports and Port C is used for handshaking.

Microprocessor, Memory map of tpa in a personal computer and explain such o...

Memory map of tpa in a personal computer and explain such of the areas in brief

Explain the chemical properties of insulating materials, Explain the chemic...

Explain the chemical properties of insulating materials. Chemical properties - Chemical resistance: Presence of gases, acids, water, alkalies and salts influences different

Transformer, What is the difference between primary and secondary winding o...

What is the difference between primary and secondary winding of transforme

What is the use of ale, What is the use of ALE The ALE is used to latch...

What is the use of ALE The ALE is used to latch the lower order address so that it can be available in T2 and T3 and used for identify the memory address. During T1 the ALE goe

What do you mean by pinch off voltage, Q. What do you mean by Pinch off vol...

Q. What do you mean by Pinch off voltage? As the voltage Vds is increased from 0 to a few volts, the drain current will increase as  determined by Ohm's law and the plot of Id

Compute the motor speed, Consider the 220-V, 1800-r/min dc motor, controlle...

Consider the 220-V, 1800-r/min dc motor, controlled by a three-phase fully controlled rectifier from a 60-Hz ac source. The armature-circuit resistance and inductance are 1.5  and

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd