Necessity of cooling system , Mechanical Engineering

Assignment Help:

Necessity of Cooling System

To prevent the engine from excessive heating.
To avoid the piston seizure due to thermal expansion.
To prevent burning of lubricant and warping of valves.
To prevent scoring of cylinders, binding of pistons and bearings.

Related Discussions:- Necessity of cooling system

Explain the information phase of radial drilling machine, Information Phase...

Information Phase: Step: To secure all and complete information and gather facts and from best sources. Our project is selected based on the current problem face by the

Features of the scheme entrepreneurship development, Features of the Schem:...

Features of the Schem: Features of the scheme are as follows : DIC is the primary registering centre. Registration is voluntary and not compulsory. Two types of

Force on string - mechanics, Force on String: A string ABCD , attach...

Force on String: A string ABCD , attached to the two fixed points A and D has two weight of 1000N each attached to it at points B and C . The weights rest with portio

Determine maximum fibre stress - beam, Determine Maximum fibre stress: ...

Determine Maximum fibre stress: A beam of rectangular section of 80 mm to 120 mm carries a uniformly distributed load of 40 kN/m over a span of 2 m an axial compressive force

Find the minimum weight to keep equilibrium, Find the minimum weight to kee...

Find the minimum weight to keep equilibrium: A belt supports the two weights W 1 an d W 2 over a pulley as shown in the figure given below. If W 1 = 1000N, fi

Determine magnitude of the couple, Determine magnitude of the couple: ...

Determine magnitude of the couple: A square block having each side 1.5 m is acted upon by system of forces along its sides as shown in the adjoining figure. If system reduces

Difference between components and resolved parts, D i f fe r enc e be...

D i f fe r enc e between components and resolved parts: 1. When the force is resolved into two parts along the two mutually perpendicular directions, the parts along th

Mechanical design of the blowdown systems, Q. Mechanical design of the blow...

Q. Mechanical design of the blowdown systems? Mechanical design of the blowdown systems shall be sized for a continuous blowdown of a minimum of 1.0% of MCR. Fabricator may re

Just-in-time, Just-In-Time: This unit begin with the discussion of Jus...

Just-In-Time: This unit begin with the discussion of Just-In-Time strategy. Several terms used in the process are also explained. JIT is an encompassing philosophy considering

Determine standard for the specific standard technical areas, Standard for ...

Standard for the specific standard technical areas These norms are based on previously described models. Typical categories of these norms are: (a) drafting, which describe

Write Your Message!

Name

Email id

Message

Verfication Code

User Account

All Pages