Multimeter-electrical instruments , Mechanical Engineering

Assignment Help:

Multimeter: This is used to measure voltage, current and resistance of an electrical circuit (Figure).

2435_Multimeter.png

Figure: Multimeter


Related Discussions:- Multimeter-electrical instruments

What is metal jacketing, Q. What is Metal Jacketing? a) Metal jacketing...

Q. What is Metal Jacketing? a) Metal jacketing shall be Alcan T-3000-H14 series, T-1100-H14 or approved equivalent stucco embossed aluminum with a factory applied moisture barr

Define trunnion jig, Define Trunnion Jig These jigs are used for drilli...

Define Trunnion Jig These jigs are used for drilling holes on very large or odd. 1. Figure shows the shaped parts from different sides. Figure: Trunnion

Show the corrosion mechanisms, Q. Show the corrosion mechanisms? The fo...

Q. Show the corrosion mechanisms? The following corrosion mechanisms are likely to happen in the Oil Treating Unit: Under Deposit Corrosion and MIC Since cooling e

Limitations of resistance welding, Limitations of resistance welding ...

Limitations of resistance welding 1). Pressure - tight joints are achieved only with flash butt welding. Resistance welding is not recommended for high pressure joints a

Lest count, what is the least count of following instrument? vernier calipe...

what is the least count of following instrument? vernier caliper micrometer bevel protractor dial

Custom-designed lap joint flanges, Custom-Designed Lap Joint Flanges Pr...

Custom-Designed Lap Joint Flanges Practices relative to lap-joint flanges, that experience has shown will result in a level of damage tolerance, leak-tightness integrity, and g

Find out the proof load in close coiled helical spring, Find out the proof ...

Find out the proof load in close coiled helical spring: A close coiled helical spring is built of 6 mm diameter wire. The coil diameter is equal to 80 mm, number of coil is 10

Power sources-transformer type power sources, Transformer Type Power Source...

Transformer Type Power Sources These are the simplest and cheapest type available for arc welding. These are the mainly used for SMAW, AC SAW and gouging applications. These are

Annotation with leaders, Annotation with Leaders Ordinate dimensions ar...

Annotation with Leaders Ordinate dimensions are not really an dimensions at all in that they do not indicate a measurement.They annotate known as a co-ordinate points. The DIMO

Write Your Message!

Captcha
Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd